PDA

View Full Version : FOR SALE: Trunk Security Plate



martyo
01-31-2012, 11:57 AM
$11 to your door.

It is this model here:

http://www.danasafetysupply.com/p-1264-1999-2011-ford-crown-victoria-trunk-security-plates.aspx

http://www.danasafetysupply.com/images/Product/medium/c-3054.jpg

CWright
01-31-2012, 11:57 AM
Can you put it in my car while it's there? I want it. Thanks Marty!

martyo
01-31-2012, 12:01 PM
Can you put it in my car while it's there? I want it. Thanks Marty!

Yes and Sold!!!

It came in the mail last night but since I am fresh out of Marauders I figured I would sell it.

marauder410
01-31-2012, 12:06 PM
gosh darn you martyy i just purchased a set of these 2 weeks ago from same place and on backorder and not gonna get for 3 weeks and paid 18.00 could have saved 7 bucks and get faster



$11 to your door.

It is this model here:

http://www.danasafetysupply.com/p-1264-1999-2011-ford-crown-victoria-trunk-security-plates.aspx

http://www.danasafetysupply.com/images/Product/medium/c-3054.jpg

martyo
01-31-2012, 12:18 PM
gosh darn you martyy i just purchased a set of these 2 weeks ago from same place and on backorder and not gonna get for 3 weeks and paid 18.00 could have saved 7 bucks and get faster

Imagine how I feel! I have no Marauder to even out them in!!!

Phrog_gunner
01-31-2012, 12:31 PM
Does this plate require drilling holes or does it use holes that are already in the trunk??

martyo
01-31-2012, 12:37 PM
Does this plate require drilling holes or does it use holes that are already in the trunk??

I did not even look at the instructions yet because it came in after I sold the Marauder it was intended for.

Phrog_gunner
01-31-2012, 12:42 PM
I did not even look at the instructions yet because it came in after I sold the Marauder it was intended for.

OK thanks. It doesnt look like self tapping screws in the pic, so I was hoping....

screamn
01-31-2012, 12:45 PM
Does this plate require drilling holes or does it use holes that are already in the trunk??

You gotta measure (use the plate as a guide) & drill holes.

Those clips go over the holes drilled then place the plate on top & screw the screw into the hole with supplied washers.

Hope that helps.

And I know......that what's she said...."screw the screw into the hole"

marauder410
01-31-2012, 03:05 PM
ok cool mine will be here in bout 2 weeks i got this item for my audio system to keep it protected this and my beast car alarm remote start, tilt sensor and motion sensor beasttt