multi funtion switch

[johnnyrauder]

on my 03 vic. when i push the squerter butten nothing happens. my auto shop says its the mfs and will cost $300.00 to fix. wtf. any input will be greatly app.

[fastblackmerc]

on my 03 vic. when i push the squerter butten nothing happens. my auto shop says its the mfs and will cost $300.00 to fix. wtf. any input will be greatly app.

Check fuse #17.

See if you get power to the washer pump when activating the switch.

[Blk Mamba]

I have a good used switch for $60, that and an hour, and you are back in business.

[johnnyrauder]

no power to pump fuse looks good

[johnnyrauder]

I have a good used switch for $60, that and an hour, and you are back in business.
how hard is it to put in?

[ctrlraven]

Last time I changed mine (which ended up not being the issue and put the original one back in), I removed the lower driver dash panel, the top and bottom steering cover, unplugged a few connectors and I think there is a few bolt screws to take out and remove the switch. Installed is reversed.

[johnnyrauder]

Last time I changed mine (which ended up not being the issue and put the original one back in), I removed the lower driver dash panel, the top and bottom steering cover, unplugged a few connectors and I think there is a few bolt screws to take out and remove the switch. Installed is reversed.
what did it turn out to be?

[ctrlraven]

what did it turn out to be?
I had the wacky wipers issue going on so I thought it was the switch, ended up being the wiper control module on the motor. Bought a new motor from Autozone and it came with a new wiper control module. It's been so long since it happened I believe I either put the old wiper control module on the new wiper motor or the new wiper control module on the old motor. I know I had to switch something up because the wipers were still not fully control correctly. I knew it wasn't the MFS when I hooked it up and put the wiper fuse back in and they still went crazy.

[johnnyrauder]

looks like you all agree $300.00 is way off...true?

[fastblackmerc]

looks like you all agree $300.00 is way off...true?

Why?

All depends on the cost of the switch, labor rate, etc.

[ctrlraven]

I bought the switch from Ford and it was $75 back then. A mechanically inclined person could complete the task in less than an hour.

Part Number is: 3W1Z-13K359-BAB

Here is a video on the replacement.
http://www.youtube.com/watch?v=WqWeB_6BOm4
WqWeB_6BOm4

I did not remove my lock cylinder, there was no need to.

[DOOM]

looks like you all agree $300.00 is way off...true?


The switch itself is $80.00 at autozone!

[johnnyrauder]

thanks birdman for that vid. at least now i know that job is out of my league.