View Full Version : Torque specs. for valve covers and camshaft bearing cap bolts???
tta197
02-05-2004, 11:34 AM
Anyone that has a helm manual, could you post what the torque values for the valve covers and camshaft bearing cap bolts are? I tried looking around on the internet and found: 71-106 in lbs. for valve cover bolts and the same torque for camshaft bearing caps. Is this correct? Thanks, I'm going to try to retorque the camshaft bearing caps to see if I can eliminate the valvetrain tapping noise my engine has. It seems that this has cured this problem for a few owners already. Thanks, Nicholas.
Petrograde
02-05-2004, 05:15 PM
Anyone that has a helm manual, could you post what the torque values for the valve covers and camshaft bearing cap bolts are? I tried looking around on the internet and found: 71-106 in lbs. for valve cover bolts and the same torque for camshaft bearing caps. Is this correct? Thanks, I'm going to try to retorque the camshaft bearing caps to see if I can eliminate the valvetrain tapping noise my engine has. It seems that this has cured this problem for a few owners already. Thanks, Nicholas.
I'm in the middle of moving right now, my manual is at my new place. I'll be back online sometime Monday, if no one has responded I'll post 'em for ya.
Tom
valleyman
02-05-2004, 09:00 PM
tta197 - per '03 shop manual: "valve cover bolts and studs -- 10 Nm/89 lb-in" "camshaft cap cluster to cylinder head -- 19 Nm/14 lb-ft"
tta197
02-06-2004, 10:44 AM
Valleyman, thanks I appreciate. Petrograde thanks also for offering.
I'll post what happens, hopefully it will fix it.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.