PDA

View Full Version : Gettin' some stuff done



Bradley G
05-01-2012, 08:22 PM
I had enough of driving the junk with the air ride out, so I dropped it off at Bob's hillview in Lake Barrington.
There it sits waiting for a new suspension compressor, I just replaced it a couple two-three years ago.
In the mean time,...
I am having Bob refresh my transmission;
starting with a new forced lube mod for the leaky tailshaft bushing, a tranny cooler, and a quart of Lucas trans additive.
I am holding off on the high stall for a bit yet , still recovering from the repaint this spring.

DOOM
05-01-2012, 08:40 PM
Git er done!!! :up:

Bradley G
05-01-2012, 09:14 PM
It's only been sitting for a week or so, I really miss it:baby:
Git er done!!! :up:

MOTOWN
05-02-2012, 12:38 AM
I had enough of driving the junk with the air ride out, so I dropped it off at Bob's hillview in Lake Barrington.
There it sits waiting for a new suspension compressor, I just replaced it a couple two-three years ago.
In the mean time,...
I am having Bob refresh my transmission;
starting with a new forced lube mod for the leaky tailshaft bushing, a tranny cooler, and a quart of Lucas trans additive.
I am holding off on the high stall for a bit yet , still recovering from the repaint this spring.

Oh im sure he is going to love installing the transmission tail shaft! the crossmember has to be removed on one side atleast, there was plenty of four letter jaw jacking going on when i did mine! lol

sounds like some nice mods:)