Cost for 4.10 Installation?

[WhatsUpDOHC]

OK, I may be ready to do this (I know, you told me so).

How much should I expect to spend for the installation?

Can anyone recommend a shop in Southern NJ?

Thanks,

Mark

[MM2004]

OK, I may be ready to do this (I know, you told me so).

How much should I expect to spend for the installation?

Can anyone recommend a shop in Southern NJ?

Thanks,

Mark

Parts and labor? Around $500.00 - $600.00

Worth every penny in my opinion.

Mike.

**edit - May cost you a little more, and does depend on your geographical location. Check our the local Mustang forums in your area. Always a good starting point.

[guspech750]

My install cost $300 and that included fluid.

Installed at a local speed shop.


Sent from my iPhone
Eaton Swap + 4.10's = Wreeeeeeeeeedom!!

[ctrlraven]

Get some gears from Sparta, they are I believe $149 right now. Then find a local Mustang shop or Ford dealer. Range that I have seen is $300-500. You will need a gear install kit as well and if you have a fair amount of mileage on the car I would replace the axle bearings/seals since the axles need to be removed anyways.

[crouse]

Check the axles too. Some have wear issues on the outside bearing end. Mine were bad. I think I paid $65 each for new axles from Ford. You'll also need to get your speedometer recalibrated. If you have a hand held tuner, that will do it.

[martyo]

How far South in Jersey are you?

I can recommend two top notch shops but it will depend on how far you want to travel.

[MOTOWN]

I paid $360 for labor that was for installing gears, a new carrier, axles, and a complete install bearing kit.

[WhatsUpDOHC]

How far South in Jersey are you?

I can recommend two top notch shops but it will depend on how far you want to travel.

I'm Northeast of Philadelphia. South of Trenton, North of Camden.

Who do you know?

FWIW - I have 65K miles - I've seen posts about mileage, bearings and driveshafts.

Thanks!

Mark

[martyo]

I'm Northeast of Philadelphia. South of Trenton, North of Camden.

Who do you know?

FWIW - I have 65K miles - I've seen posts about mileage, bearings and driveshafts.

Thanks!

Mark

http://fordsnationalautomall.dealerco nnection.com/?lang=en

or Kevin Hand at Wicked Motorsports

[Bruce K]

My local shop charged me 4 hrs labor.
I supplied the gears and install kit (Richmond).
They had to use some of their shims to dial it in.

[92BlackGT]

im paying $175 next weekend for the labor. paid $259 shipped for the gears, install kit and fluid.