Need Help removing the old emblems

[MMG1989]

Whats the best way to remove old mercury emblems and put on the new god head emblems? Need help

[fastblackmerc]

Whats the best way to remove old mercury emblems and put on the new god head emblems? Need help

Fishing line and heat will get the teunk one off.

The front one has a retaining nut if I remember.

[Marauderman]

Whats the best way to remove old mercury emblems and put on the new god head emblems? Need help


Fishing line and heat will get the trunk one off.

The front one has a retaining nut if I remember.

I think you need to clarify--Jim ^^^^above is referring to something different I think---what do mean?--The front or the rear emblems--?? It's best to be specific to get the exact answer

[Ms. Denmark]

Fishing line and heat will get the teunk one off.

The front one has a retaining nut if I remember. Jim's correct. You can use a plastic putty knife too. Tape off the area to avoid scrapes and take your time on the trunk. The fronts are bolts. Not too difficult. Did you get one like this?

29198

[MMG1989]

Yo be exact im talking about all 3 Steering wheel, Grille, and Trunk

[Ms. Denmark]

Yo be exact im talking about all 3 Steering wheel, Grille, and Trunk For the steering wheel, do it on a warm day, disconnect the battery and use a thin screwdriver to slowly and carefully pry it up. It's held on with 6 tabs. This is my new one.

[MMG1989]

I ordered my God Head Emblems from CarMotorSports with the tape on the back i know the grill is a screw on so I was wondering how do I put the grill emblem on because it has the screw in part sticking out and i think my trunk emblem is slanted i was wondering was that normal and is the steering wheel emblem goin to be able to stick on the steering wheel?

[fastblackmerc]

I ordered my God Head Emblems from CarMotorSports with the tape on the back i know the grill is a screw on so I was wondering how do I put the grill emblem on because it has the screw in part sticking out and i think my trunk emblem is slanted i was wondering was that normal and is the steering wheel emblem goin to be able to stick on the steering wheel?

After you remove the grill emblem you'll have to shave the mounting pad down for the new emblem to fit.

The trunk emblem is bigger than the grill emblem and has a slight curve to it to match the contour of the deck lid.

The steering new wheel emblem sicks on over the OEM one.

[MMG1989]

After you remove the grill emblem you'll have to shave the mounting pad down for the new emblem to fit.

The trunk emblem is bigger than the grill emblem and has a slight curve to it to match the contour of the deck lid.

The steering new wheel emblem sicks on over the OEM one.
So just stick the new one on top of the factory mercury emblem?
And how did you get the trunk off?

[RF Overlord]

And how did you get the trunk off?Saw it off with fishing line.

[MMG1989]

Saw it off with fishing line.
LOL ok i will try my best with this one didnt know that was the way to do it

[marauder410]

i didnt stick my god head emblem over the OEM will stick out and noticable if ur paticualar like i am with my MM it need to be done right the first time around like they said :

disconnect the battery n wasit a min for the horn to die and warmer inside the car is the better will come off easy and take a small thin flathead and EASY jus pry it off i put a peice of electrical tape over the thinest flathead to didnt scatch up the steering wheel and then stick the godhead down i got the saem ones as you and thats the right way to do it

but if you dont care then jujst stick it over the OEM one but ITS WILL stick out a littel bit i kno trust me

front one bolts and saw off the little clicp things so the fornt godhead will fit flush

back one take fishing line like said above or i used a good dental floss that worked for me pray a little windex or water to loose it up then jus saw through with the dental floss or fishing line its a pretty easy mod and they LOOK SO BAD AZZ good luck with the installation

[MMG1989]

what object did yall use to shave the piece down on the front grill

[MMG1989]

i didnt stick my god head emblem over the OEM will stick out and noticable if ur paticualar like i am with my MM it need to be done right the first time around like they said :

disconnect the battery n wasit a min for the horn to die and warmer inside the car is the better will come off easy and take a small thin flathead and EASY jus pry it off i put a peice of electrical tape over the thinest flathead to didnt scatch up the steering wheel and then stick the godhead down i got the saem ones as you and thats the right way to do it

but if you dont care then jujst stick it over the OEM one but ITS WILL stick out a littel bit i kno trust me

front one bolts and saw off the little clicp things so the fornt godhead will fit flush

back one take fishing line like said above or i used a good dental floss that worked for me pray a little windex or water to loose it up then jus saw through with the dental floss or fishing line its a pretty easy mod and they LOOK SO BAD AZZ good luck with the installation
Thank you very much with the play by play installation it was much needed just need to know what did u use to plow down the front grille piece?

[marauder410]

i used a dremel

[Rockettman]

Just checked these out. Wow they're nice. Expensive though. (for me anyway).

There must be other places to get them? (Besides EBay - cause you don't know what you're gonna get).

(The one Ms.Denmark has with the number is awesome.)

[Ms. Denmark]

Just checked these out. Wow they're nice. Expensive though. (for me anyway).

There must be other places to get them? (Besides EBay - cause you don't know what you're gonna get).

(The one Ms.Denmark has with the number is awesome.)
My trunk/grille and steering wheel emblems are all from Colex, a vendor here. They are beautifully made, so well worth the price IMHO. Just save your pennies...:D

[Rockettman]

^^^ just went to their link. Useless!

Would be interested to look, but can't. I really like the number idea. Very unique.

[fastblackmerc]

I'm working with my supplier on gods head badges.

[Rockettman]

Jim,
the one thing that I'm overly interested in, is having "my" number on an interior emblem. Are you heading in that direction? Metal or plastice?

[Zim Hosein]

I'm working with my supplier on gods head badges.

Please keep us updated fastblackmerc! :beer:
Edit: I forgot to add, please try to have the front grill emblem a direct bolt-in replacement that does not require any "additional" work, I'd hate to purchase one and mess up while shaving a piece of it for a factory fit! :o