Wideband

[Mike M]

Where did you run the harness from your air/fuel gauge going to your wide band?
Did you have to drill a hole in the firewall or is there room somewhere I don't know about?

I plan to weld the bung in front of one of the primary catalytic converters as I assume that will give the most accurate readings.

I think I have settled on a AEM...any thought?

[Vortech347]

I have an AEM as well on my fox and I love it. It's been a great wideband and the sensors are just a simple easy to replace Bosch.

[03sport007]

Where did you run the harness from your air/fuel gauge going to your wide band?
Did you have to drill a hole in the firewall or is there room somewhere I don't know about?

I plan to weld the bung in front of one of the primary catalytic converters as I assume that will give the most accurate readings.

I think I have settled on a AEM...any thought?

I had the same question when I installed my AEM(love it by the way). There is a nice factory hole just in front of the driver side front seat. Pull the carpet back easy to get to piece of cake.

[blazen71]

There is a grommet next to the brake booster.

[Mike M]

Where are you guys mounting the sensor? I assume in front of one of the primary cats?
Not much room right next to the frt o2 sensor.

[drewb457]

You want to mount it in front of the cats, it doesn't have to be before the O2S. Does anybody run two widebands due to true duals?

[LANDY]

In front of the cats. If you don't have them you can put it in the middle of the x-pipe.