View Full Version : People with DDM Tuning HIDS Help!
DetroitPanther
06-13-2012, 01:56 PM
Ok, I bought some DDM Tuning Hids about a year and a half ago and never installed them.
I went to install them today and they wont turn on.
I remember some people on here awhile back were having the same problem and it was caused by the wiring that the DDM Hids come with being in the wrong positions or something like that?
Any help would be appreciated.
ctrlraven
06-13-2012, 02:15 PM
http://www.mercurymarauder.net/forums/showthread.php?t=53542
If you don't have these color wires, let me know!
http://img560.imageshack.us/img560/3588/1127101804.jpg
DetroitPanther
06-13-2012, 02:45 PM
Aw, man. I thought the marauder had the same headlight set up as Crown Vics. I have a Vic and my hid kit doesn't have the white wire, but the black and red are in the correct spot. Thanks though, sir!
ctrlraven
06-13-2012, 03:23 PM
If you only have black and red, it sounds like you just have a single LO beam kit. Did you order the single or hi/lo kit?
From left to right (ie picture I posted)
High Beam (Blue or Red) ---- Ground (Brown or Black) ---- Low Beam (White or Yellow)
DetroitPanther
06-13-2012, 04:58 PM
Hmm I actually don't remember. I THINK just the low beam... hopefully the HIDS I have are the correct ones for my car?
I just messed with them again, switching ballasts and such and still no luck. Not sure what the problem is, might see if they are under warranty if I can't figure it out.
Just went through my email and found the order as well:
Wattage : 35 Watt
Bulb Type : 9007
Bulb Color : 10000K
ctrlraven
06-13-2012, 05:23 PM
Did it come with something like this? If not you just have the single low beam kit. Turn your lights on and flip on the high beams, if they come on then you need to swap the pins on the plugs that connect to the factory headlight plug.
http://i11.photobucket.com/albums/a164/ctrlraven/marauder/DSCF26021024x768.jpg
DetroitPanther
06-13-2012, 05:31 PM
Nope, do not have that^
And yessir, my regular high beams do come on.
So I need to swap the red and black pins on the blue connector as pictured below? (minus the white wire)
http://img560.imageshack.us/img560/3588/1127101804.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.