blower motor or EATC?

[johnnyrauder]

the wifes 03 vic. is not blowing out any air i can hear the blend door moveing and some heat trickels out of the vents, defrost and floor. if i hit the a/c i can hear it click on under the hood but doesn't blow. thanks for any input.

[fastblackmerc]

Try tapping the BCM. Located under the hood, passenger side, behind the cam cover, has one electrical connector and should have an orange & white label on it. If the blower motor works, then you need a BCM. P/N: YW1H-19E624-AA

[johnnyrauder]

thanks i'll try that. what does BCM stand for?

[fastblackmerc]

thanks i'll try that. what does BCM stand for?

Blower Control Module

[johnnyrauder]

DUH!! thanks

[johnnyrauder]

i saw a connector with a orange an white wire tapped it but no dice

[fastblackmerc]

i saw a connector with a orange an white wire tapped it but no dice

The orange and white is the label on the part, not the wires. Do it with the blower motor on.

[J-MAN]

Try tapping on the blower motor too. Set the manual blower switch on high first.

[johnnyrauder]

thanks but i can't find it any place

[fastblackmerc]

thanks but i can't find it any place

It's mounted to the HVAC case, below where the heater hoses enter the case and behind the passenger side cam cover.

[fastblackmerc]

Check out this thread:

http://www.mercurymarauder.net/forums/showthread.php?t=48707