SW long tubes outside of the engine bay?

[CNGInterceptor]

Hey everyone!

I haven't posted here in quite a while, but I had a quick question.

I'm just about ready to drop my Cobra engine in between the fenders, and I was curious if anyone's installed the SW long tubes outside the vehicle, and if the DOHC with long tubes will fit between the frame rails dropping it in.

I don't want to hang them and lock them down with the Stage 8's, only to find out it doesn't fit from the top. Thanks in advance!

[MOTOWN]

Yes they will fit installed on the motor before installation

[Loco1234]

Yes, I have done in my maruader 3-4times.... easiest way..
Even did w/ tranny attached once...

[Blown3.8]

Yes an engine leveler helps. Also taking the shift cable bracket off the driver frame rail helps too.

[CNGInterceptor]

Thank you so much for the responses! I don't need to worry about the shifter cable bracket, as the T56 is next.

Anyone on CVN can check out the progress here:

http://www.crownvic.net/ubbthreads/ubbthreads.php?ubb=showflat&Number=2501414#Post2501414

[MOTOWN]

Looks like you got some Wreeeeedom in your future!

[CNGInterceptor]

^ thank you! It's coming along really nice, and I hope to be up and running soon.

[License2Bill]

Dibs on the Eaton once you go with the Whipple

[CBT]

Thank you so much for the responses! I don't need to worry about the shifter cable bracket, as the T56 is next.

Anyone on CVN can check out the progress here:

http://www.crownvic.net/ubbthreads/ubbthreads.php?ubb=showflat&Number=2501414#Post2501414

Good stuff! :beer:

[CNGInterceptor]

Thanks guys! It means a lot to hear some praise.