View Full Version : '03 wire harness
Bruce Wayne
01-28-2013, 09:47 PM
Is there a difference between an '03 and an'04 wire harness? I am swapping out an engine and would like to know of any surprises.Thanks
justbob
01-29-2013, 05:35 AM
IIRC the '04 only has one knock sensor. I would think all the other pinouts on the ECM would be the same?
Sent from my iPhone 4s using Tapatalk
Bruce Wayne
01-29-2013, 07:50 AM
can anyone tell me where the knock sensors are located.. Thank you
guspech750
01-29-2013, 08:06 AM
Im pretty sure 04's have two knock sensors. They are located under the lower intake manifold.
Sent from my iPhone 4S
DTR + 4.10's + Eaton swap = Wreeeeeeeeeeeeeeedom
guspech750
01-29-2013, 08:13 AM
You can see in this picture where the knock sensor locations were ground down in preparation for an Eaton swap. One on each side in the valley there on the 2004's n
http://img.tapatalk.com/d/13/01/29/qusuvaju.jpg
But that is where they are located.
Sent from my iPhone 4S
DTR + 4.10's + Eaton swap = Wreeeeeeeeeeeeeeedom
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.