Pedal Problems?

[License2Bill]

My pedals haven't moved since long before I bought the car so this past Wednesday I ordered the gear from Curless and had it in my hand on Friday (holy cow that was fast). I followed the repair instructions to a T and the pedals still don't move. :bigcry:

Is there a fuse I should check or do I need to take a Voltmeter to the assembly? The factory gear was one part of the problem, since that was cracked right through.


-Bill

[SC Cheesehead]

PM 03mmmonroe, he just finished up his replacement and maybe can give you some tips.

[fastblackmerc]

My pedals haven't moved since long before I bought the car so this past Wednesday I ordered the gear from Curless and had it in my hand on Friday (holy cow that was fast). I followed the repair instructions to a T and the pedals still don't move. :bigcry:

Is there a fuse I should check or do I need to take a Voltmeter to the assembly? The factory gear was one part of the problem, since that was cracked right through.


-Bill

Make sure there is power to the pedals. If not, check fuse # 602 (20A) in the power distribution box under the hood, behind the battery.

[License2Bill]

Thanks I'll check that our.

Another question... Any idea what this is? It was hanging down after dropping the courtesy cover.

33609

Sent from my EVO using Tapatalk 2

[fastblackmerc]

Thanks I'll check that our.

Another question... Any idea what this is? It was hanging down after dropping the courtesy cover.

33609

Sent from my EVO using Tapatalk 2

Doesn't look factory.

[rocky]

Thanks I'll check that our.

Another question... Any idea what this is? It was hanging down after dropping the courtesy cover.

33609

Sent from my EVO using Tapatalk 2

Cop chip?


Sent from my iPhone 5

[Blackened300a]

Your car have a remote start? That looks like the box where a key would be installed to override the PATS.

[ctrlraven]

Does that tan wire penetrate the firewall?

[License2Bill]

No remote start and it does not penetrate the firewall. As far as I could tell, it just goes straight up into the dash and ends on a banjo bolt type of thing near the adjustable pedal switch. I will try and get more pictures tomorrow.

[jb513]

Need a better picture. Definitely not a factory piece. The factory doesn’t tape things up like that! looking at it I can see clips on either end that would pop into a square hole. It might be a leftover dash light from an aftermarket alarm. Is there any holes in the dash? If not, the guy may have not wanted to cut a hole and just stuck it up there. A better Pic would help though.

[License2Bill]

Also, the fuse is still good. Seats still move and power lumbar works as well

Sent from my EVO using Tapatalk 2

[fastblackmerc]

Are you getting power to the pedals?

[Curless]

Disconnect the cable going to the brake pedal assembly and see if the gas pedal moves...

[License2Bill]

Fbm, i don't think I'm getting power since the gas pedal does not move with the brake cable disconnected

Sent from my EVO using Tapatalk 2

[RF Overlord]

Do you hear any sounds at all from under the dash when actuating the switch? Any clicks, clunks, humming...anything? If not, then you have either a wiring problem or the pedal motor is croaked.

[fastblackmerc]

Fbm, i don't think I'm getting power since the gas pedal does not move with the brake cable disconnected

Sent from my EVO using Tapatalk 2

Check if you have power at the 7 pin connector.

Pin 2 - power at all times

Pin 1 - power when operating switch forward

Pin 7 - power when operating switch rearward

Pins 3, 4 & 6 - grounds

Pin 5 - interior lights

If no power, check fuse #602 (20A) in the power distribution box under the hood, behind the battery. You can swap it with #118 (ABS) to test