View Full Version : misfire #4 and # 8
maineiac
04-30-2013, 06:20 AM
whats the pattern of our cylinders,are theses the two rear?
Marauderjack
04-30-2013, 06:27 AM
Yep.....facing the engine the passenger's side is 1-4 (front to back) and the driver's side is 5-8....Good Luck!!:beer:
maineiac
04-30-2013, 06:29 AM
thanks ,hopefully just the coils,but i replaced them lkast aug with ford mo co.
Marauderjack
04-30-2013, 06:30 AM
Remove the coil covers and look for water in the spark plug tubes.......those are bad to leak when washing the engine!!:shake:
burt ragio
04-30-2013, 07:23 AM
What indication leads you to mentioned # cylenders are not firing ?
1) Check spark plugs & gap use anti seize.
2) Re install cop use electode grease & listen for click good conection.
3)Swap cop to comfirm bad cop.
maineiac
04-30-2013, 07:48 AM
SCT tuner misfire #4 and #8
maineiac
04-30-2013, 01:03 PM
Two new ford coils,dealership replaced them free since they where ony 8 months old,seems to run fine,but check engine light still on ,can i reset the code using my SCT tuner?
babbage
04-30-2013, 01:16 PM
Two new ford coils,dealership replaced them free since they where ony 8 months old,seems to run fine,but check engine light still on ,can i reset the code using my SCT tuner?
Yes you can reset the CEL with the SCT device. "clear DCT's" is what you want...
Also I'd suggest a rear head cooling mod and or a better waterpump. Cly 8 is the dreaded hot spot -- dead end for coolant. The extra heat can cause all kinds of failures.
maineiac
05-19-2013, 12:51 PM
Cylinder # 6 now WTF
Motorhead350
05-19-2013, 01:17 PM
Have you pulled the coils yet?
maineiac
05-19-2013, 01:26 PM
brand new ford ones in AUG 2012,ford replaced two bad ones for me just last month,going to see them tomorrow for a full set of replacements !
babbage
05-19-2013, 03:06 PM
You can get a set from Sparta on this site cheaper than dealer..
maineiac
05-19-2013, 03:08 PM
Already bought them back in August,they are going bad so i hope they will replace,they did the first two no questions asked.If not sparta here i come!
Marauderjack
05-19-2013, 03:24 PM
If the tabs on the low voltage plugs break they will not lock onto the coils and misfires will occur......check that all are locked on!!:cool4:
I had one break and soldering in the replacement was not much fun!!:shake:
maineiac
05-19-2013, 03:58 PM
thanks i will check those too.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.