View Full Version : Wideband 02 sensor bung location
Blackened300a
05-07-2013, 05:54 AM
Just curious where you guys are welding the 02 bung for your wideband sensor. I have SW long tube headers and a custom H pipe after the extension lead pipes out of the cats. This is my after Carlisle installation.
lilmarauder
05-07-2013, 06:29 AM
Obviously you know to install before the cat. I'll post up a pic of my setup when I get home today.
RF Overlord
05-07-2013, 01:00 PM
Lidio put mine in the down-pipe right before it curves under the car.
I would ass-ume with headers it would go in the collector as far from where the individual pipes come together as possible.
RacerX
05-07-2013, 02:21 PM
This helps too:
SC Cheesehead
05-07-2013, 02:40 PM
This helps too:
Nice find! Thanks for postng. :up:
loud2004marquis
05-07-2013, 03:05 PM
Nice find! Thanks for postng. :up:
+1
Good stuff there.
justbob
05-07-2013, 04:21 PM
Lidio put mine in the down-pipe right before it curves under the car.
I would ass-ume with headers it would go in the collector as far from where the individual pipes come together as possible.
I always weld it in same place. Yes it's after the cat, no it doesn't matter, readings are the same. AFR confirmed on dyno.
On long tubes, I weld it right into the left header collector facing driver side slightly angled upwards. Then I run the wiring to the body drain directly in front of the seat.
Self proclaimed Builder Of Badassery.
03mmmonroe
05-07-2013, 05:48 PM
Just curious where you guys are welding the 02 bung for your wideband sensor. I have SW long tube headers and a custom H pipe after the extension lead pipes out of the cats. This is my after Carlisle installation.
I installed my wideband sensor in the Oem or stock location and then welded the new bung on the inside towards the transmission. Works fine.
Comin' in Hot
05-07-2013, 06:39 PM
Thanks for the info, I was just talking to Paul about this and he beat me to it.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.