lilmarauder
05-07-2013, 07:19 AM
I have a lower intake for a eaton swap. It needs work though. There is a hole drilled in the bottom that needs to be welded shut. It is 3/8 in diameter. Don't ask how it got there cause I don't know.
There is a bung welded on for the iat sensor. The bung is a terrible idea because the iat sensor would not be able to get a good reading, because the sensor is set back so far. The threads are destroyed. The bung needs to be cut off flush, the hole needs to be filled with weld, and then it can be drilled and tapped for a iat sensor.
Also this particular Intake has a slight wobble when set on the heads with no gasket. Approximately a 1/16 of a inch gap when you put weight on the front or back. It wobbles from corner to corner. The gaskets make up for the wobble. It will work without vacuum leaks, but a machine shop can fix it.
Besides all that, its in good shape. The blower mating surface, and all the bolt holes are in good shape. The intake to cylinder head mating surface and holes are in good shape, and the intercooler adaptor mating surface and bolt holes are in good shape as well.
So, considering the work it needs ill let it go for 50 plus shipping. I dont want to throw it away cause it can be fixed and used. These are hard to find anymore. Hope this helps someone out that is motivated.
http://img.tapatalk.com/d/13/05/07/uby2e2eb.jpg
http://img.tapatalk.com/d/13/05/07/za9e6u6u.jpg
http://img.tapatalk.com/d/13/05/07/dehabu4a.jpg
http://img.tapatalk.com/d/13/05/07/atejagu6.jpg
There is a bung welded on for the iat sensor. The bung is a terrible idea because the iat sensor would not be able to get a good reading, because the sensor is set back so far. The threads are destroyed. The bung needs to be cut off flush, the hole needs to be filled with weld, and then it can be drilled and tapped for a iat sensor.
Also this particular Intake has a slight wobble when set on the heads with no gasket. Approximately a 1/16 of a inch gap when you put weight on the front or back. It wobbles from corner to corner. The gaskets make up for the wobble. It will work without vacuum leaks, but a machine shop can fix it.
Besides all that, its in good shape. The blower mating surface, and all the bolt holes are in good shape. The intake to cylinder head mating surface and holes are in good shape, and the intercooler adaptor mating surface and bolt holes are in good shape as well.
So, considering the work it needs ill let it go for 50 plus shipping. I dont want to throw it away cause it can be fixed and used. These are hard to find anymore. Hope this helps someone out that is motivated.
http://img.tapatalk.com/d/13/05/07/uby2e2eb.jpg
http://img.tapatalk.com/d/13/05/07/za9e6u6u.jpg
http://img.tapatalk.com/d/13/05/07/dehabu4a.jpg
http://img.tapatalk.com/d/13/05/07/atejagu6.jpg