Log in

View Full Version : Fog Light Assembly easy?



engine23ccvfd
03-17-2004, 06:23 AM
Hello All,

I gto the dreaded rock to the fog light assembly and had to order a new assembly. Anyone changed one out yet. According to some instructions I found you need to lift the front of the car. Anyone been able to change the assembly by squeezing under the car w/o benefit of a lift? Any pitfalls to watchout for?

Thanks

Jinfla
03-17-2004, 08:25 AM
You have to jack the car up. There is a access panel with velcro holding it down just behind the fog lights you push this up to get to the fog lights. There is three screws that hold the fogs in place and one plastic push pin on the bottom. It is a shame you had to order a new one as I have a marauder that I am parting out that has both fog lights.



Hello All,

I gto the dreaded rock to the fog light assembly and had to order a new assembly. Anyone changed one out yet. According to some instructions I found you need to lift the front of the car. Anyone been able to change the assembly by squeezing under the car w/o benefit of a lift? Any pitfalls to watchout for?

Thanks

CRUZTAKER
03-17-2004, 03:55 PM
I did mine laying on the floor with the front wheels turned opposite the are you need to reach.
By far easier to lift the car a little.