Transmission builder recommendations

[Comin' in Hot]

I am looking for a performance transmission builder in the somewhere around eastern PA, I need to have my trans tailshaft swapped and do not want to send it back to Lentech due to outrageous shipping costs to Canada.

I thought I read somewhere there was one in Maryland or Delaware?

[Curless]

The housing or the actual shaft?

[RacerX]

If it's the actual output shaft, the entire trans needs to be dissassembled. In which case you'll want it refreshed anyway. These guys are well known and in NY: http://www.fbperformance.com/Contact-Us

[Comin' in Hot]

The both, Lentech builds them with the shorter of each meaning my driveshaft is 1 inch too short.

The easy route would be to have a driveshaft made 1 inch longer, but I don't know if that's a good idea due to the issues of these driveshafts at high speeds

[RacerX]

Driveshaft spacer should work...

http://www.puresuzuki.com/SS1559cfs.jpg

[Comin' in Hot]

I could always have a Dynotech carbon fiber driveshaft made and I would feel safe then, I'm open to suggestions

[Comin' in Hot]

I already have a spacer, I don't like the idea of it with my goal of around 650+ rwhp

[MOTOWN]

Ill be going this route for my shaft! LINKY http://www.dennysdriveshaft.com/p1400_1350_series_4_inch_alumi num_driveshaft_with_chrome_mol y_slip.html

[Comin' in Hot]

I just ordered a 4" 6061 aluminum Dynotech driveshaft 1" longer than stock to fix the problem.

[Comin' in Hot]

It arrived today
http://i22.photobucket.com/albums/b335/Witman40/7D1826FB-8CA5-4256-B9C0-B0CC908F377D-1089-000000A9672D70C9_zpsecdd75d4.j pg

[RacerX]

Doesn't look right. Send it to me for testing...

[Comin' in Hot]

Doesn't look right. Send it to me for testing...

You're right, it was made to stock length, it's totally useless to me.

[RacerX]

You're right, it was made to stock length, it's totally useless to me.
:eek: They going to take care of that prob?