Help- Tape needed

[Comin' in Hot]

I'm looking for some high temperature tape to rewrap my battery harness. I'm trying to put new clips on the battery harness where it runs along the passenger side cam cover and attaches to the cam cover studs. I was going to use electrical tape, but I want to make sure that the heat from the header doesn't cause the tape to fail.

Any suggestions?

[RubberCtyRauder]

Might be something in here that you can order or find locally.

http://www.summitracing.com/search/part-type/heat-tape?kr=heat%20tape&SortBy=None&SortOrder=Ascending

[Haggis]

Ryan is coming over on sunday to work on his E-brake. While he is busy I will remove some from his car and sell it to you dirt cheap. :shhh:

[Mebot]

Wait a minute....

sent from a Samsung Galaxy far far away...

[babbage]

I'm looking for some high temperature tape to rewrap my battery harness. I'm trying to put new clips on the battery harness where it runs along the passenger side cam cover and attaches to the cam cover studs. I was going to use electrical tape, but I want to make sure that the heat from the header doesn't cause the tape to fail.

Any suggestions?

Something like this perhaps:

http://www.cesco.com/b2c/product/79770?gdftrk=gdfV25445_a_7c184 7_a_7c7081_a_7c79770&gclid=COKJxNaIlLkCFQyk4AodiXsA ug


Good for temps up to 356 Deg F. Put a zip tie on the ends where tape stops/starts - then it can't unravel.

[Haggis]

Wait a minute....

sent from a Samsung Galaxy far far away...

Shhhhh.....don't tell Ryan. :hide:

[wannaMM]

Electrical supply houses carry a Fiberglass tape with adhesive on 1 side..1-2" widths
1-2 layers of that with a Hi-Temp cover tape(Available in colors) and you'll be right as rain....I used to Weld/gouge on a regular basis with 600A+ load on the cables and this setup would stop the "arcing out" on the workpeice...Good Luck...