MMC Driveshaft question

[clintons4]

I just got a used MMC driveshaft. I need to know if the the front slip yoke is correct for our car. Also if the U joint is the correct size for the pinion yoke for our car. Looking to have new u joints installed and have it balanced.

[Zack]

Just take it to the driveshaft shop and have it rebuilt.

Its a direct bolt-in

[clintons4]

Just take it to the driveshaft shop and have it rebuilt.

Its a direct bolt-in

That is all I needed to know brotha. That is where I am taking it, just didn't know if I needed to change anything on it.

Thanks :beer:

[fastblackmerc]

That is all I needed to know brotha. That is where I am taking it, just didn't know if I needed to change anything on it.

Thanks :beer:

Should be a direct bolt in.

[ctrlraven]

While you are at it, might as well put on a DS safety loop as well if you ever plan on running a lot of power, just another cheap insurance mod.

[fastblackmerc]

While you are at it, might as well put on a DS safety loop as well if you ever plan on running a lot of power, just another cheap insurance mod.

+1! :banana2:

[DEFYANT]

While you are at it, might as well put on a DS safety loop as well if you ever plan on running a lot of power, just another cheap insurance mod.
...............
Agreed

[clintons4]

...............
Agreed


Where is the best place to buy? Is there one that bolts in? I don't want to mess around welding something.

[Zack]

Metco has them

[clintons4]

I found a vendor that has them for $89 shipped. Is this the best price on them?

[tbone]

At what point is a driveshaft loop required at the track? When your runs are under 14 seconds, like the helmet rule?

[justbob]

At what point is a driveshaft loop required at the track? When your runs are under 14 seconds, like the helmet rule?


Don't matter for you Mr. Eaton man. Any car with an aftermarket S/C or turbo no matter your E.T.

Or 13.99 or quicker on slicks for all others

Or 11.49 or quicker on streets for all the quicker others...


Self proclaimed Builder Of Badassery.

Buy it, Break it, Build it BETTER.
"Since 2004"

[tbone]

You think I should get one Bob or a waste of money with my upcoming setup?

[Zack]

You think I should get one Bob or a waste of money with my upcoming setup?

I went 11.99 @ 116 with my Eaton swap back in 08? 09? and the car still has the stock driveshaft.
I am replacing it with a Dynotech I had laying around now that its considerably faster.