View Full Version : Steering binding
burt ragio
02-27-2014, 05:22 PM
Trying to chase down a steering problem. I have run Trans Go through the steering pump system as well as changing out all fluid. I have replaced the steering shaft. It still binds when turning from left to right. Are there any known issues I can address ?
justbob
02-27-2014, 05:32 PM
I found that disconnecting the sensor on the pressure hose will create on again/off again power steering and it will feel as if it's binding. Perhaps check the harness that plugs into it.
It is more on the passenger side between the radiator and engine right along side the sway bar.
Self proclaimed Builder Of Badassery.
Buy it, Break it, Build it BETTER.
"Since 2004"
fastblackmerc
02-27-2014, 06:25 PM
I found that disconnecting the sensor on the pressure hose will create on again/off again power steering and it will feel as if it's binding. Perhaps check the harness that plugs into it.
It is more on the passenger side between the radiator and engine right along side the sway bar.
Self proclaimed Builder Of Badassery.
Buy it, Break it, Build it BETTER.
"Since 2004"
+1..... the connector can get gunked up. Some brake clean can fix it.
Bruce Wayne
02-27-2014, 08:06 PM
try replacimg lower steering shaft, we ship out hundreds of them lately
Bruce Wayne
02-27-2014, 08:07 PM
oops sorry , i see you already did that
fastblackmerc
02-27-2014, 08:15 PM
try replacimg lower steering shaft, we ship out hundreds of them lately
You work for the manufacturer?????
burt ragio
02-28-2014, 08:23 PM
Ended up being a bad U joint in the shaft between the steering wheel & fire wall. On order @ $150.00 Should be here Monday afternoon.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.