Check This Out

[joflewbyu2]

http://www.ADTR.net/ they have a cold air intake kit, larger throttle bodies & more.

[SergntMac]

http://www.ADTR.net/ they have a cold air intake kit, larger throttle bodies & more.
Nice looking selection of accessories for sure, thanks! Have to watch your step though, as far as I could tell, very little there would be an improvement to a Marauder.

[woaface]

I damaged my airbox in the and IF the insurance company ok's the deal, they'll not buy me a new one, but let me buy my own, they'll then take $125 of the cost of my deductable.

I'm going for the cold air from ADTR...:D :up:

[joflewbyu2]

Anyone Try These Products. They Have The Addco Front And Rear Sway Bars As Well As The Cai Kits Too.

[Marauder]

I had bought the stage 1 intake kit for my Crown vic and it maybe quite a difference!!!

[woaface]

I had bought the stage 1 intake kit for my Crown vic and it maybe quite a difference!!!
Boy am I glad to hear that! I've bought mine and it'll be here tomorrow!

[darebren]

so with all the folks looking for a cold air intake kit, no one has tried this yet? see description:
Mercury Marauder factory airbox assembly
Replaces your stock airbox with a larger snorkel, redesigned top lid and a 80mm mass air flow sensor. Flows more air than stock and increases horsepower.

Adds around 7-10 hp
Bolts to the same locations on your Panther fender well
REQUIRES A COMPUTER TUNE!

What would need to be adjusted in the computer???


they also have a replacement 65MM throttle body...is the MM a 65MM stock?
See description:
Designed for Ford’s 4-valve modular V8 motors, these throttle bodies are direct bolt-on in about fifteen minutes. They outflow the stock unit by approximately 30%. This represents a gain of around 10-12 horsepower with no adverse effects on gas mileage or drivability.

CNC Machined
High Quality 356 Aluminum
O-ringed Shafts And Die Stamped Linkages
Direct Bolt-On Replacement
One Year Warranty
Fits on Bullitt intake equipped Panthers

HP & Torque: 10-12 HP/12 ft lbs Torque

Installation: Directly replaces stock throttle body. Bolts on in under an hour, only hand tools are required.


are we talking a 20 hp bump for both items here?? looking for confirmation these will work with the MM, and what to have done with the computer to make it work.. could Dennis reprogram the chip and how do we ask him to do it...?