Scan gauge selection

[Pat]

Installed my new scan guage II and am ready to rock and roll.:banana:

What four guages do you initially display on your scan guage instrument?:confused:

I'm choosing MAP/BST, FIA/CIA, LOD and IGN. :type:

MAP/BST= measures boost pressure
FIA/CIA= Inlet air temperature
LOD= Engine Loading
IGN=amount of advance or retard

There are 17 different guages that can be displayed. Four at a time.
The FPR, fuel pressure, is not supported.
The "X" guage feature allows more but I'm not that far along yet. :thinker:

[RF Overlord]

Pat, figure out the X-gauge part...it also allows you to look at TFT: Transmission Fluid Temperature.

[2,4shofast]

I use the intake air temp, water temp, transmission temp and mpg settings

[ctrlraven]

RPM, MPH, Trans Temp and Water Temp.

[fastblackmerc]

RPM, MPH, Trans Temp and Water Temp.

Same here.

[fastblackmerc]

Mine installed:

http://i167.photobucket.com/albums/u133/fastblackmerc/MM%20Mods/ScangaugeII/DSCN0010.jpg (http://s167.photobucket.com/user/fastblackmerc/media/MM%20Mods/ScangaugeII/DSCN0010.jpg.html)

[Sully008]

Voltage, IAT, Water Temp, Fuel Pressure.