Radiator fan install

[MM03FPG]

I'm going to install the RF any tips or tutorials would be helpful thanks.

[camelgrundle]

Put the bolts in and plug it in! Easy peasy

[fastblackmerc]

Remove the old one, install the new one. Very, very easy.

[myrodr]

pinch off hoses and pull out old one put in new one fill then open hoses. this saved me from having to burp the system

[MM03FPG]

pinch off hoses and pull out old one put in new one fill then open hoses. this saved me from having to burp the system


I appreciate the tip. Thank you Sir

[8UWITH6]

pinch off hoses and pull out old one put in new one fill then open hoses. this saved me from having to burp the system

Huh? Cooling fan is two 10mm bolts and lift.

[camelgrundle]

Lol. He must have a fan that's filled with coolant! Unless you mean the radiator as well?

[Blackened300a]

8mm socket. Remove the coolant reservoir and power steering reservoir. Move them off to the side. You may wanna crimp the small hose that connects to the coolant reservoir just so you can move it further away.
On the left and right side are a 8mm bolt that faces forward. Remove those two bolts and unplug the fan. Then lift and tilt slightly to clear the radiator hose.

To replace, the lower left and right section of the fan has tabs that will fit into plastic holders on the radiator. Make sure the fan is sitting in those holders then tighten up the bolts and replace the reservoirs and plug in the fan.
No burping of system required even if the small overflow hose is removed.