hood alignment help

[mercury5]

I tried searching the previous post , without luck on the aftermarket fiberglass hood alignment, it seems to be a little out of align on one side , any ideas/suggestions would be greatly appreciated, oh, by the way, had the TCE brake lines installed today , wooooow, you talk about a big difference, I love them:banana:

[tbone]

Is it high, low, off in relation to the fender, what is the issue?
A pic or 2 would be helpful.

[mercury5]

It's too far down and too far from the nose clip, and fender to fender it's perfect on the driver side but too much of gap on the passenger side.

[tbone]

Rubber stops thread in and out to adjust the front height. Hinges have screws that bolt into the fender to allow up and down movement and bolt into the hood to allow forward, back, and pivoting motion.The fender can be loosened at the bolts on top and pushed in a little.

[mercury5]

:banana:thanks so much for the help:bows: