Air suspenion

[Jolly Roger]

So here it is,
I finally got around to installing the front factory springs with the 1 coil cut off.
I also installed the camber kit.
Next stop will be the wheel alignment shop for Carfixer spec alignment.
While on the lift I adjusted/moved the air suspension sensor all the way to the drivers side but now air bags don't pump up.
I turned the switch off in the trunk before I started and back on when the car was back on the ground.
Started it up but no compressor sound.
Is there such a thing as moving the switch arm to far to the drivers side causing something not to engage as it should?
Or did I move it to the wrong (drivers) side?
Rear suspension was at full travel when switch adjustment was made.
Was that wrong?
Perplexed.:(

[RubberCtyRauder]

I know it only takes minimal movement of height sensor to get results. I believe they are pretty sensitive with like barely moving it. How far did you move it? Half inch? Inch? I thought they only needed like .125 movement

[justbob]

A 1/4" towards the drivers side is usually a good starting place for cut coils and factory height tires.


Builder Of Badassery

[burt ragio]

Move ride height sensor slightly and see if it makes a dif. Check 30 amp fuse under hood. Check 15 amp fuse in cabin on drivers side. If fuse is good disconnect susp. pump and check for current. If good 12.5 amp you have a bad pump.
I just ordered a new pump from Arnott. the other day.

[Jolly Roger]

Ok guys,
sounds like I went to far over with the adjustment.
I'll try again with less movement.
Thanks?;)

[MOTOWN]

You definitely went too far , the airbags will never fill in that position