Transmission in a Bind

[95chickn]

This is my first time trying to install a 4r75w transmission. I bolted up and proceeded to try an turn engine to put in torque converter bolts, and wouldn't budge. The converter studs are catching/rubbing on that little separation plate thing:confused::help:
Is there a certain way that goes in?
It might be bent? Idk
Is it really needed?

[Zack]

If you don't line the studs up upon installation, you need to unbolt the trans and move it backward.
There is no other way

[88grandmarq]

you didnt seat the torque converter fully... it should clunk in place 3 times and the torque converter stud should be below the bell housing

[Marauderjack]

you didnt seat the torque converter fully... it should clunk in place 3 times and the torque converter stud should be below the bell housing


^^This^^:shake:

[95chickn]

^^This^^:shake:

That was it:depress:

[fastblackmerc]

you didnt seat the torque converter fully... it should clunk in place 3 times and the torque converter stud should be below the bell housing


That was it:depress:

Look above............... ^^^^^^^^^^^^^^^^^^^^

[loud2004marquis]

^^^what he said^^^

[95chickn]

"That was it"..... as in that's what worked:gunfire:

[lji372]

I concur, especially after you said that was it :lol: