Back Glass Rubber Trim Loose

[Fastbob]

Has anybody had any problem with the back glass exterior black rubber trim moulding coming loose? Mine is loose at the bottom near the deck lid most of the way across just above the deck lid. What needs to be done to fix this? New moulding or reattach? I haven't messed with it yet.

Thanks

[RubberCtyRauder]

Mine does it on the pass.side. I will add a dab of black silicone to it and be done.

[03Merc]

Happened to mine as well. Passenger side. I just put a couple drops of super glue on the inside of the strip.


2004 - MM 1618 - DTR 537

[ctrlraven]

Mine does it on the pass.side. I will add a dab of black silicone to it and be done.
Passenger side for mine too. Make sure you clean the channel where the glass slides into first before adding any silicone. I noticed mine collected a lot of it which is why it wasn't holding onto the glass anymore.

[fastblackmerc]

Clean it well, both the channel and the glass. Put some black silicone sealer in the channel, use some masking or painters tape to hold in place for 24 hrs. I did this to mine 3 years ago and it's holding up fine.

[Fastbob]

Thanks for the input, I'll glue it back in place this weekend. I guess when the get old they start to fall apart (Just Like Me).

[JOEMERC]

I had the same issue not long after I bought new ,forget what kind of glue I used but its held up ever since .