PDA

View Full Version : Escape Radio Aux Input?


rbh
12-02-2015, 04:50 PM
Replaced the original radio with an Escape 6 CD 6l8t-18c815-FD. The only adapter I can find on the forum PIE frd03* aux/s and it is no longer available. I'm just looking to add a 3.5mm jack to plug my phone into utilizing either the SAT or AUX input on the radio. Anybody have an alternative?

Randy
Mebot
12-02-2015, 04:53 PM
Where are you looking? Have you tried eBay?

Can't stop the signal...
rbh
12-02-2015, 05:01 PM
Ebay,Amazon, Cruthfield, etc.etc
Mebot
12-02-2015, 05:56 PM
Maybe try calling some local audio installation places. Might get lucky or maybe they can point you in the right direction

Can't stop the signal...
rbh
12-04-2015, 05:28 PM
Oem Autosound says this will work. Will let those interested know when it arrives.

http://www.oemautosound.com/p-480-aux-adapter-ford-lincoln-radios.aspx
Chevyguy
12-04-2015, 07:09 PM
You can get a new aftermarket head unit with AUX and Bluetooth for that price point
rbh
12-04-2015, 08:10 PM
I like the factory look.
NavySeabee
12-04-2015, 08:16 PM
Oem Autosound says this will work. Will let those interested know when it arrives.

http://www.oemautosound.com/p-480-aux-adapter-ford-lincoln-radios.aspx

Post up how it turns out with pics. May be my next project.
Turbov6Bryan
12-04-2015, 08:17 PM
Car I picked up has the old school tape with a iPhone headphone jack hanging off it
I bet it sounds great LOL
justbob
12-04-2015, 11:06 PM
You can get a new aftermarket head unit with AUX and Bluetooth for that price point


For $140 bucks? Not in my car. [emoji6]


Builder Of Badassery
rbh
12-30-2015, 08:29 AM
Installed yesterday. Plug and play as far as the wiring. That being said adding the extra harness ended up being a major pain. Had to cut out a small section on the left side to make room for the extra 24 pin plug. Then the cabling for the rca box had to be pulled through from the back to get the radio to go in. There is almost but not quite enough room for my hand and arm to go through the opening for the eatc after removing the trim and module to pull the cable through from the back of the radio. As much of a pain in the ass as it was the escape radio looks factory and the aux plug for music will be mounted in the console. Sounds good with pioneer speakers and the factory sub. Like most things it would most likely be quicker if I had to do it over. Down side is now to remove the radio the EATC module and trim will have to be removed to to remove the radio. Pictures when the rest of the interior is in.(might be a while)

Randy

http://www.oemautosound.com/p-45-ford-pie-frd03-aux-s.aspx