I know nothing
So, I tried to change the axle seals this weekend. I removed the rear wheels, brake calipers and wheel sensors. I removed the rear cover, but couldn't get the axles to push in far enough to remove the C-Clips. There was only about 1/4" of play in and out. What am I doing wrong?
I know nothing
This is the best video I've ever seen on the replacement of clutches.
https://www.google.com/search?sca_es...J9h_-t_e0,st:0
I know nothing
Would removing the pin allow the axles to push in farther?
NEED FOR SPEED
Yes the big pin in the center has to be removed. When the seal leaks it usually means the axle and bearing is bad, but maybe just junk seals. u-tube must have video's of pulling axles.
73TORINO SPORT 112K M. BOUGHT NEW
03 BLK 9K M.
07 GT500 13K M.
98 MARK VIII 75K M. BOUGHT NEW
21 EXPLORER PLATINUM 3.0
18 GENESIS G80 5.0
54 GMC
Senior Member
Did you remove the abs sensors, you need to at least move them in about 3/8" if you don't want them off completely and remove the center pin to get them pushed in far enough to get the c clips out.Originally Posted by crouse
I know nothing
I did remove the ABS sensors, but not the pin.I'll try again this weekend. At least I have the re-useable gasket now.
Axles, bearings and Motorcraft axle seals were new about 10k miles ago. I Auto-Cross my Marauder, so that gear lube is getting thrown side to side. Should I apply a little RTV on the outside of the bearing to seal it against the axle housing?
Senior Member
Put the RTV around the perimeter of the seal before you put it in the housing. If you change your mind about a girdled cover a have a couple to sell.
NEED FOR SPEED
Be sure the vent is not plugged.
73TORINO SPORT 112K M. BOUGHT NEW
03 BLK 9K M.
07 GT500 13K M.
98 MARK VIII 75K M. BOUGHT NEW
21 EXPLORER PLATINUM 3.0
18 GENESIS G80 5.0
54 GMC
I miss whitey here
Don’t spin the axle when the pins removed, you will spit the spider gears out.
id just rtv the cover, not the bearings or axle seal
The twins2.3 whipple/aluminatorVortech V-2 lots of goodies
Current marauders
04 DTR totaled JUST NOW starting to part out 7-21-2021 https://youtu.be/REUxjP1BVpg
04 Silver Birch Dark Charcoal Hardtop Whipple Supercharger
04 Silver Birch Dark Charcoal Hardtop V2 Supercharger
04 Silver Birch Dark Charcoal Converted
03 DBP Light Flint #122
03 DBP Dark Charcoal #232
03 Silver Birch 300b Light Flint Going to fix er up
03 Black 300a
04 Silver Birch Dark Charcoal moonroof in the works
04 Heaton Swapped DTR
Joe's Wrecked DTR rebuild thread
I know nothing
Good advise. Thanks.
I know nothing
Thanks. In the video link I posted, the guy has a good technique for putting them back in.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote