Junior Member
What is a good overall front coil and shock set up, that won't break the bank, same with rear. 03 Marauder has 163k on what I think is stock suspension. Going with Addco front and rear sway bars, but kinda stumped on the rest. Any advice is greatly appreciated.
Ryan
Senior Member
Following!
Sent from my 2PS64 using Tapatalk
Member
I have KYB's on my Marauder.
Some people use Monroe Severe duty for Police cars.
Senior Member
My vote is Monroe SD in front, KYB in rear
2003 300A Black, #4918 of 7838, 17,400 Miles
Tune, KYB's, JLT, FlowMaster 42441, Res Delete, New BFG's, 8 coats of zymoil Titanium
2003 300B Silver Birch, #21 of 419, 29,800 miles
Tune, JLT, FlowMaster 42441 Res Delete, New Nitto 235/255 Bigcarsforever dead peddle & custom SRP peddles, 5 coats Zymoil Titanium, Addco front and rear sway bars, KYBs, 1/2 inch coil cut, Sparta Watts link and Control Arms, Carfixer alignment.
2003 CV Sport Matador Red, 19,280 Miles, DD, Curless Full Service Royal flush, Marto Tune, 18 Chrome Wheels w 235/265 front/back Nitto tires, NEW OEM Sport Springs -1 coil & Monroe Severe Duty (front) shocks, Addco front and rear sway bars, KYB rear Shocks, Carfixer Alignment.
2004 CV HPP Silver Birch, 93,000 miles. Son's DD, 18 Chrome Wheels w 235/265 front/back Nitto tires (thank you Lowndex!)
Junior Member
I have had oem, kyb, Monroe. Then stock springs cut 1" with same combo. Then QA1 double adjust. Out of all the QA1 were best but they would bottom out not enough travel. I will try Ride tech HQs next time around. My tires bounce like basketballs & no it is not worn shocks they have done that since day one.
2004 marauder black purchased new. Sold 9/16 at 297,000 miles. Still ran strong didn't burn a drop of oil.
2003 marauder black 28,000 miles all stock. Garage Queen.
2004 marauder red daily driver.
Weißbirke Plünderer
I will get my car back soon from MO's..Had them put Ridetech HQ on with 700 lb spring as they are not progressive rate. ADAM has the ridetech's on wi tht he standard 650 spring and he likes them so far. I almost went QA1 but read too many people took them off for not staying in adjustment, bottoming out, sagging over a year. Naake made this kit up and used a 450 lbs spring. I think they would have done better using a 550 spring or 600. They do have other springs ratings. I'll put ridetech HQ shocks on the rear after I get the car back most likely.
2004 SB Ported Trilogy 48
Has supporting mods and stuff
Thanks to Marty O for his help in updating this car.
R.I.P.
Rex "SC Cheesehead"
Member
Deleted....... posted to wrong forum....
Last edited by vicateurlilss; 08-23-2017 at 09:51 AM. Reason: Deleted
Junior Member
What spring rate & height did you go with using Viking ?
2004 marauder black purchased new. Sold 9/16 at 297,000 miles. Still ran strong didn't burn a drop of oil.
2003 marauder black 28,000 miles all stock. Garage Queen.
2004 marauder red daily driver.
Junior Member
Viking web site is down.
2004 marauder black purchased new. Sold 9/16 at 297,000 miles. Still ran strong didn't burn a drop of oil.
2003 marauder black 28,000 miles all stock. Garage Queen.
2004 marauder red daily driver.
Mike
Could somebody chirp in some part numbers for kyb shocks and springs for the front, and already have springs/shocks in rear, (PO did it, but not very well), Looking for rear springs and shocks. Part numbers please.
Member
Originally Posted by burt ragio
I didn't want to post any of that here.. it was my mistake..
And as for answering your questions. Ones that fit
Sent from my iPhone using Tapatalk
Member
Yeah.. Viking website don't work...
Sent from my iPhone using Tapatalk
Still Rocking Four Doors
I went KYB-HDs all around with cut coils up front & 2013 Mustang springs in back. Combined with the Addco sway bars, spherical links, & spherical control arms, this boat handle FLAT. And I only have a few hundred into it. I promise it'll compete all day with a pricier coilover setup.
2005 Mercury S55
Saleen Supercharged 2V
Member
Haha not enough spring rate... in the front end..
Sent from my iPhone using Tapatalk
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
