Outside door handle gap
Anyone else seen this on their MM? Didn’t really notice till I was looking from underneath.
Only on the passenger side on mine. It’s like the handle and gasket are pulling away from the door. I’m concerned about water getting past it and inside the door.
I’m wondering if I take the door panel off if this can be tightened from the inside?
BTW, funny it’s on this side; 4 years ago this door panel was “fixed” by a hack body shop who caused more problems than they fixed, after someone hit me. This could be a leftover from their work.
Sent from my iPhone using Tapatalk
Last edited by Svashtar; 01-05-2020 at 02:10 PM.
2003 black pre-decontented 300B #5886 of 7838; Born on 10/31/02
MartyO tune, 4:10's, T/A stud & girdle, MMX shaft+DS loop, Metco control arms, Quickor RSB, Addco FSB, Megs delete tips, Granatelli solid coil connectors, NGK plugs & LP 170 stat, DR rear engine cooling mod, PI 3000 TC, Level II tranny, Art Carr deep pan, Steeda pullies/billet caps, billet door locks, Ford Racing oil cap / polished coil covers, PHP CAK & Metco carbon fiber intake, DG Motorsports CF radiator cover, Fumoto oil drain valve, oil deflector, real Autometer gauges, ScanGauge II, Weatherflectors, underbody lighting kit, Zack chrome grill, OEM spoiler & door edge guards, KB dead pedal, Dynopro aluminum sills & pedals, Viper alarm w/ remote start, MM fender badges, red painted calipers, SS inserts, Silverstar Ultras, hood bumpers, 35% tints, Gorilla lug nuts, MM valve caps, Pro-Guard, DD trunk lid liner, CM UHI kit, CM Godshead rear & steering wheel badges, S-55 badge, FilterMag, MM trunk bib, ported sub-woofer.