P2195 - O2 Sensor Signal Stuck Lean Bank 1 Sensor 1
What the title says. The code just appeared this morning while warming the car up for my drive to work. The only work I did on the car was a LF sway bar link replacement the night before, completely unrelated but I've heard stranger stories.
I checked all wiring, connectors, etc and all seems fine. The only thing I havent looked into is the wiring from that sensor a part of the wire bundle that comes up behind the engine and has rubbing problems causing weird electrical issues sometimes?
I still have my old O2 sensors back when I did my Eaton swap so plan A is to just put one of those back in to see if the problem goes away. Eaton swapped folks, is this a common occurrence since EGT's are now higher? Keep in mind, I'm not exactly a baby with the throttle. What else should I be looking at?
2004 Silver Birch w/moonroof. "Isabelle"
Eaton swapped summer/fall 2015 with all the gooddies, tune by the one-and-only Marty-O +2psi pulley, Steigemeyer stage 6 port, SWLT, custom ss exhaust, Borla ProXS, Addco sway bars, TCE s/s brake hoses, Hawk HPS pads, Zack big brak kit, J-mod, battery in trunk, full custom audio (never used, blower whine sounds better)
To do list:
HID headlights, LED interior/exterior, courtesy "3-flash" turn signals, widen wheels, rear deck wing, marauder stencil on cmhsl? bumper cover inserts? deck lid, steering whee, hood liner godshead, more power!