Need a little advise. Sent the Trilogy out for a rebuild and was told the actuator is shot. IS there anything I can use to replace the old actuator since it is a Trilogy specific part.THANKS
Need a little advise. Sent the Trilogy out for a rebuild and was told the actuator is shot. IS there anything I can use to replace the old actuator since it is a Trilogy specific part.THANKS
You talking about the boost bypass valve? Isn't that the same as a normal eaton? The Trilogy blower is a Magnuson design and Magnuson based the "MP112" on the Eaton M112, it shouldn't be some super proprietary Trilogy part.
2016 Ford Mustang GT PP - Lund nGauge, BMR vertical links, MGW Shifter, BMR CB005
2004 Mercury Marauder - Eaton M112, Billetflow 3.4, Accufab SBTB + Plenum, T-56 Magnum, 4.10s, Stainless Works LTs, 2.5" Exhaust, Borla Stingers, Ridetech Coilovers + Adj rear shocks, FX-R projectors, Wilwood 13" BNSL6 + FNSL4 BBKs, S55 Gauge Cluster
440rwhp & 406rwtq Tuned by Adam @ Revolution Automotive
2063/3214
(Sold) 2003 Mercury Marauder - Stainless Works LT's, Stainless Works 2.5" Catback, JLT Intake, Mo's Xcal4 Tune
5377/7838
2000 BMW M5 - Evolve Intake, Evolve Alpha-N tune, Stoptech ST-40 BBK, UUC SSK, Dinan front STB, Dinan RSB
1996 Ford Bronco - 4" lift, 35" BFG A/T's, Punisher Valve Body, MH1 Projectors
I am almost positive that it is a different part in how it mounts and the proper orientation than a typical Eaton.
I know I went thru great lengths trying to find one made for high lift cams at one time and ultimately gutted mine and trimmed the internal spring to delay its closing. Hopefully this is not what I am remembering but I think I was trying to get a new replacement before I did surgery on mine.
I can say it was quite easy to open and reseal with silicone. Unless your diaphragm has an actual tear in it (and you would have known as the blower would have been screaming at you even at idle or you would have zero boost or sound for that matter) I can’t see why you couldn’t open it up to check the diaphragm and spring, clean, and reseal it easily.
Your rebuilder could very well just be looking to cover his work with new parts? I’m sure they go bad like anything else but I’ve yet to witness one personally.
There should be a part number on the bracket and JonBondPerformance lists quite a few.
I’d call Jerry Barnes if you hit a dead end.
Sent from my iPhone using Tapatalk Pro
Last edited by justbob; 07-05-2020 at 07:55 PM.
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.
Was this the recently sold silver? Nice car man.
The twins2.3 whipple/aluminatorVortech V-2 lots of goodies
Current marauders
04 DTR totaled JUST NOW starting to part out 7-21-2021 https://youtu.be/REUxjP1BVpg
04 Silver Birch Dark Charcoal Hardtop Whipple Supercharger
04 Silver Birch Dark Charcoal Hardtop V2 Supercharger
04 Silver Birch Dark Charcoal Converted
03 DBP Light Flint #122
03 DBP Dark Charcoal #232
03 Silver Birch 300b Light Flint Going to fix er up
03 Black 300a
04 Silver Birch Dark Charcoal moonroof in the works
04 Heaton Swapped DTR
Joe's Wrecked DTR rebuild thread
There was a guy in So. FL that sold Magnuson parts and I cannot find his info for the life of me. I will PM ya if I get lucky
It is not the same as an Eaton.
Guittard22 had a Trilogy unit he talked about selling, I think it needed a rotor.. maybe use as parts blower
2004 SB Ported Trilogy 48
Has supporting mods and stuff
Thanks to Marty O for his help in updating this car.
R.I.P.
Rex "SC Cheesehead"
I had to buy one and swap the canister to my bracket.
This is who i was told to get in contact with:
You can contact brian@superchargersonline.com
They are our authorized rebuild shop and they handle all the parts for the older superchargers.
(818-518-9889) ask for David or Brian.
Thank you
Tim
Those were the days.........
DANG THEY'RE CUTE!!!!!!
Smile and Nod
I love THIS bar
Thanks everyone. This web site is a wealth of info. for these great cars!!!
Call Magnuson. They have a kit to replace the original actuator. Its $150.
Florida Vanity Tag 03 MARDR
Former Traffic Homicide Investigator For Hillsborough County SO in Tampa.
Retired US Air Force
v. ma·raud·ed, ma·raud·ing, ma·rauds
v. intr. To rove and raid in search of plunder.
v. tr. To raid or pillage for spoils.
[French marauder, from maraud, tomcat, vagabond.]
ma·rauder n. [From Maraud, v.: cf. F. maraudeur.] A rover in quest of booty or plunder; a plunderer; one who pillages.
marauder n : someone who attacks in search of booty [syn: predator, vulture]
Here is the contact info. They sent me a new IAV setup to go with the new actuator.
Derik Lindberg, Account Manager
Magnuson Products LLC.
1990 Knoll Drive, Building A
Ventura CA 93003
Office + 1.805.642.8833 X282
Direct + 1.805.639.8381
www.magnusonsuperchargers.com
Florida Vanity Tag 03 MARDR
Former Traffic Homicide Investigator For Hillsborough County SO in Tampa.
Retired US Air Force
v. ma·raud·ed, ma·raud·ing, ma·rauds
v. intr. To rove and raid in search of plunder.
v. tr. To raid or pillage for spoils.
[French marauder, from maraud, tomcat, vagabond.]
ma·rauder n. [From Maraud, v.: cf. F. maraudeur.] A rover in quest of booty or plunder; a plunderer; one who pillages.
marauder n : someone who attacks in search of booty [syn: predator, vulture]
For what it is that is insane pricing.
Sent from my iPhone using Tapatalk Pro
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.
There are currently 1 users browsing this thread. (0 members and 1 guests)