Results 1 to 2 of 2

Thread: Those dang transmission cooler lines!

  1. #1
    Join Date
    Oct 2020
    Location
    Chandler Arizona
    Age
    61
    Posts
    37

    Those dang transmission cooler lines!

    Guys, any idea how to route these from the transmission ports up past the starter, motor mount, then connect line-joining bracket to the bottom of the AC cannister before hooking up the hoses from the radiator? Looks like there is also a connector/bracket that might bolt up to the block? Been trying for a few hours...no luck.

    FYI - the cooler lines were completely de-installed as I had the engine and tranny rebuilt. At this point I have the engine and tranny back in.

    Thanks

  2. #2
    Join Date
    Oct 2020
    Location
    Chandler Arizona
    Age
    61
    Posts
    37
    ok guys, as usual, ya stick with it long enough, ya figure it out
    1)route the lines starting on the tranny side, push the line through the space between the motor mount and the block, along side the oil pan
    2)drop the power steering u-turn hose (single bracket bolt) to make room
    3) most important, drop the sway bar (4 large nuts, 2on each side)
    Everything should fit through at that point with a little wiggling applied.
    tcooler1.jpgtcooler2.jpgtcooler3.jpgtcooler4.jpgtcooler5.jpgtcooler6.jpgtcooler7.jpg

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. OEM Trans Cooler Lines.....
    By Marauderjack in forum Transmissions
    Replies: 16
    Last Post: 02-06-2016, 09:27 AM
  2. Transmission cooler lines, output and return?
    By dmjarosz in forum Transmissions
    Replies: 13
    Last Post: 06-02-2014, 02:10 PM
  3. queeeesssstion - tranny cooler lines
    By 4drpower in forum Transmissions
    Replies: 5
    Last Post: 11-05-2010, 11:48 AM
  4. transmission lines
    By burt ragio in forum Transmissions
    Replies: 1
    Last Post: 10-13-2007, 03:53 PM
  5. Transmission Lines
    By burt ragio in forum Community Discussion
    Replies: 0
    Last Post: 10-13-2007, 01:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •