How do you remove the shifter?
I understand there is a sleeve you have to move. hoW DO YOU MOVE IT?
How do you remove the shifter?
I understand there is a sleeve you have to move. hoW DO YOU MOVE IT?
Grab ahold and pull straight down. Allen screw heads facing the dash side if I remember correctly.
Sent from my iPhone using Tapatalk Pro
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.
BLACKMARAUDER04 - How do you remove the shifter? I understand there is a sleeve you have to move. hoW DO YOU MOVE IT?.
- move the shifter in the N(eutral) position. *makes everything easier.
- grasp the black plastic collar and push down. *it will slide-down, just takes a little effort.
- remove the two torex set-screws on the back of the shifter shaft.
- slowly lift-up on the shift knob while holding the selector button -or- wrap tape around the knob to hold it. *this is so that the button and spring don't jettison.
- unplug the O/D switch wire.
There are currently 1 users browsing this thread. (0 members and 1 guests)