I have a new oil pressure switch and gauge.... I am trying to take of the electrical connection and I know you need to push down on the clip but it will not budge.
Anyone been through this?
I have a new oil pressure switch and gauge.... I am trying to take of the electrical connection and I know you need to push down on the clip but it will not budge.
Anyone been through this?
Just cut the wire, You need to anyways for a real oil pressure sending unit.
Sent from my iPhone using Tapatalk Pro
yeah I did not want to cut the wire but guess I have to since the new pressure switch just has a screw to hold the wire..... Thanks....
I was able to take the old oil pressure switch and used the connector from that and soldered a wire to it that attached to the new oil pressure switch... No cutting....I believe it is just the oil pressure switch that is the issue... I did not change the gauge and now it reads about 33 PSI and when I rev the engine it goes up to about 50....I will eventually put in the new gauge...
There are currently 1 users browsing this thread. (0 members and 1 guests)