Sketchy H pipe replacement
I don’t understand all the clamps? I mean someone took the time to do the bird mouth cuts and welding so why not weld it all? Unless this is the kit you were referring to and you installed it? Then I understand if you don’t have a welder.
Not sure about a crown Vic H pipe fitment but I do know for a fact the gaskets are not only 100% identical in every way but are also 3-4 times cheaper at some places and stocked vs ordering. Been there more than once.
Sent from my iPhone using Tapatalk Pro
Last edited by justbob; 01-06-2022 at 05:37 PM.
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.