What in general goes bad when a module decides to die (you pick the module)? Bad connection, software, burned out somethingerother, other?
GAME OVER, YOU LOSE!
What in general goes bad when a module decides to die (you pick the module)? Bad connection, software, burned out somethingerother, other?
Everything Marauder, LEDs & HI
Depends on the module. Most are bad connections, undersized relays, etc.
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
GAME OVER, YOU LOSE!
Based on your experience if you open up a module how feasible is it to diagnose where the issue is? Do you need highly specialized equipment, or can you diagnose with an ohm meter or other garage type home equipment? I know it depends, but in general.
Open Channel 'D'
First, you tell the bad module to go sit in the corner. Then you yell "Bad Module! Bad! Bad!" at it. After a while, they generally behave.
"That's what." - She
Kenny Brown Mercury Marauder 'S' - Kenny Brown Signature Edition #10 of 10
Silver Birch #126 of 4,453
Mercury Division, Ford Motor Company, Panther/Marauders #7,221 of 7,839
MercuryMarauder.Net Member #111 (!)
Everything Marauder, LEDs & HI
With the headlight relays I have physically opened the relay to find burned contacts.Originally Posted by Mr. Man
On the LCM circuit borad there is usually a brown spot cause by over heating around the headlight relay as seen in the attached photo.DSCN0031.jpg
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
GAME OVER, YOU LOSE!
Thanks FBM
Senior Member
On the EATC blower motor module you can tell right away for the burn circuit and it can be fixed be simply soldering a piece of wire...
[/quote]
On the blend door actuator, it's not a module but nature they all fail sooner or later, it just stops working or the gears inside crack. replace the whole part is needed.
One the wiper control module, it's another module that will fail on you sooner or later, the module is attached to the motor, if the wiper cowl get's flooded or rain water the moisture penetrates the module and then you will have the wipers syndrome where only high speed work or they come off randomly even when they are in the off position, in worse cases the washer fluid squirt all by itself. for this, you can try to open the module and allow to dry and reinstall but low % success, whole motor needs replacement.
2003 Mercury Grandma on steroids
Senior Member
2003 Mercury Grandma on steroids
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
