Avic-D3 / Sub / Amp / Speakers / XM Install

[arejayesss]

Contrary to info Rich found at a website, the following is the correct wiring for the four speakers:

Front Right Speaker POSITIVE- White / Light Green
Front Right Speaker NEGATIVE- The other one, duh!! (Green / Orange)
Front Left Speaker POSITIVE- Orange / Light Green
Front Left Speaker NEGATIVE- Light Blue / White
Rear Right Speaker POSITIVE- Orange / Red
Rear Right Speaker NEGATIVE- Brown / Pink
Rear Left Speaker POSITIVE- Gray / Blue
Rear Left Speaker NEGATIVE- Tan / Yellow


IMPORTANT: This wiring information is provided by Rich, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Rich assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. Rich assumes no liability or responsibility resulting from an improper installation, even in reliance upon this information.

[Drewstang]

I have retained the measurements for this box. I will gladly make you one in any stage of completion. It could be cut wood, assembled wood, carpeted, fully loaded, whatever, and then ship it to you. This size will accommodate most quality 10" woofers on the market. PM me.

Further, I have a way to get the stock radio to play an after-market amp.

Will do. I was an installer at Best Buy for nearly a year. I've done everything besides building boxes, and that is because my mechanical skills far exceed my carpentry skills.

[magindat]

IMPORTANT: This wiring information is provided by Rich, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Rich assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. Rich assumes no liability or responsibility resulting from an improper installation, even in reliance upon this information.

Now THAT's good stuff, right there!!!!! However, upon this color code, Ryan's speakers were all wired correctly and in phase. But don't come cryin to me if you screw it up!!!!

[magindat]

OK, John and mods, this one is ready for a sticky at the top of John's forum. It now contains all the reference info I've ever needed to do a Marauder system and would be a great place for one-stop info.

Sticky Please!!!!!

[SILVERSURFER03]

I like the sub placement. iv'e got to 12in subs takes up to much trunk space..how does it sound there.. like i said looks real good

[arejayesss]

I like the sub placement. iv'e got to 12in subs takes up to much trunk space..how does it sound there.. like i said looks real good

Sound is phenominal, whether I've got an old Dick Dale song on, or Tool, or Bette Middler (wind beneath my wings). There is a suprising amount of bass available to me. I put on 'Don't Phunk With My Heart' by the Black Eyed Peas and WOW!! Ghetto phabulos!! But, when I put in a good hard rock n' roll song, the bass is sharp and precise. This is all thanks to Richs ear and his tuning, along with the science he applied to everything including the construction of the sub box.

[traveleriii]

Is that a full size spare in the trunk?...If so did any cutting or anything have to be done to do so?

[Pops]

They were able to leave the full size spare in the trunk. This worked out nice!

[magindat]

Is that a full size spare in the trunk?...If so did any cutting or anything have to be done to do so?

No cutting in the trunk, just careful measuring.

[duhtroll]

Thanks for the thread reference!

Just out of curiosity, what am I looking at as far as costs go, ballpark, for this setup?

[Pops]

I need to know what all you want to do. PM me with a list and I will figure it out for you. You can also call at 269 637 1994.

John

[magindat]

Thanks for the thread reference!

Just out of curiosity, what am I looking at as far as costs go, ballpark, for this setup?

Same setup is

Avic D3 w/kit/harness
MTX 300 amp
MTX 5500 10" sub
Cabling/etc
I'll build and line the box for $150. Or John can price it for ya and I'll pass on the measurements.

[arejayesss]

Same setup is

Avic D3 w/kit/harness
MTX 300 amo
MTX 5500 10" sub
Cabling/etc
I'll build and line the box for $150. Or John can price it for ya and I'll pass on the measurements.

Don't forget the speakers!! Pioneer Premiers (REVs)

Yeah, that MTX 300 AMO is great, you won't be firing blanks anymore!!

[musclemerc]

That is one SEXY install.... You must be a good boy to deserve that kind of help. Great job Rich! Coming from a home automation tech you made it look like a professional installation

[magindat]

Damn nice trunk setup!

Sent email. My PM's are screwed up.