Addco sway bar (front).

[Jolly Roger]

Just finished installing my front Addco sway bar.
Simple install took about an hour, would have been a half hour had I noticed that the holes in the Addco bar where the end links bolt up were smaller than the holes in the factory bar.
Once that was discovered everything fell right into place.
I simply drilled the holes out to the same size as the ones in the factory bar.
You might check this before you start and save 15 min. or so of wondering why the end link bolts won't go into the holes provided.

[Seneca]

Just finished installing my front Addco sway bar.
Simple install took about an hour, would have been a half hour had I noticed that the holes in the Addco bar where the end links bolt up were smaller than the holes in the factory bar.
Once that was discovered everything fell right into place.
I simply drilled the holes out to the same size as the ones in the factory bar.
You might check this before you start and save 15 min. or so of wondering why the end link bolts won't go into the holes provided.

Thats a good heads up, I seem to remember that when i was helping someone else install the front sway bar, It throws ya off for a min.

[BlackIce]

Be sure to report back and let us know what you think of the results.

[Jolly Roger]

Be sure to report back and let us know what you think of the results.

Still awaiting the rear one, even though they were both ordered from DR at the same time.

[offroadkarter]

Still awaiting the rear one, even though they were both ordered from DR at the same time.

Dont worry, eventually it will get there