Ported Short Runner Intake Results!

[nazman]

Ok Guys/Gals,

Today we did spent some quality time at the dyno with a Marauder! Yes!

We did some back to back testing of one of our custom Ported Short Runner intake on STOCK long block Marauder!

Here is the combination BEFORE DYNO:

Custom Cold Air Intake
Ported Intake (not ported by Nazty Performance)
Welded Glass Packs
No Tune

Her is the combination AFTER DYNO:

Everything the same, replaced ported intake with Nazty Performance Ported Short Runner Intake

RHWP:







RWTQ:




Unfortunately, we did not have a stock intake to compare with! We estimate that the gains would have been 30+RWHP when compared to the stock intake.

As you guys can see, these are huge gains ALL ACROSS the power band with no losses anywhere! Further more, effectively extending the RPM range WELL within the stock parameters!

Another thing to notice is that we did not touch the tune. With tuning, we anticipate another 10RWHP gains!!!

Huge Kudos to "BAD FIVE O" who voluntered his MM for the dyno testing!

Have some more pics and videos to load later this evening!

Naz

PS. This WILL BE the 1st MM in the 12s all motor.

[Raudermaster]

Very cool. Some good results.

[BAD FIVE O]

Thanks Nazty Performance it runs like a bat out of HELL!!!!!!!!!!!!!
Here is my baby's dyno run http://videos.streetfire.net/video/N...der_679775.htm

[ImpalaSlayer]

naz has mine been shipped yet?

[nazman]

naz has mine been shipped yet?

Yes! It went out!!!!



Naz

[ImpalaSlayer]

SWEET!!!!!!!! disreguard last pm then. thanks man!

[DTRMiguel]

Yeah a 01' Cobra put down 383RWHP/365RWTQ, Stock Short Block with the HCI stage 2 option.

[sd8683]

SWEET!!!!!!!! disreguard last pm then. thanks man!

I HATE you!!!!!

[Joe Walsh]

I like the results, but as they say: "Nothing is for free"....

How do the numbers compare from 2500 rpm up to 4400 rpm?
A street driven car spends most of it's time below 3,000 rpm.
I wouldn't want to lose a lot of low end torque to get the high end HP, at least not in a 4300 LB automatic trans Marauder.

[ctrlraven]

Nice work Nazty! Stock baseline dyno for most MM's are 235-240rwhp 245-250tq on the average.

[Blackened300a]

Nice work Nazty! Stock baseline dyno for most MM's are 235-240rwhp 245-250tq on the average.

So when you taking the plunge?? Im actually debating on doing this but I havent had the greastest luck lately working on my own car.

[ImpalaSlayer]

im very anxious to recive mine

[Blackened300a]

im very anxious to recive mine

Are you going to do a write up of the install?

[ctrlraven]

So when you taking the plunge?? Im actually debating on doing this but I havent had the greastest luck lately working on my own car.

Divorces are costly man lol plus I still have 4.10 gears to do hit the track to see where I'm at before taking the plunge on the intake manifolds and of course LT header & full exhaust, pulleys, etc etc.

[ImpalaSlayer]

install is very simple i dont see it being nessesary????