Senior Member
I had a few EGR parts left over from making EGR adaptor's for the shorty header swaps and decided to make use of the left over hardware. These are the block off's for the EGR pipe on the DS header, all you have to do is make a block off for the upper intake and your done. I will give them to anyone who want's them (2 total). They have been pressure tested and water tested then painted with a satin black finish. You pay to ship!
...
nice offer, i just cut the end off, pinched it shut them welded it. not the prettiest but it works
2010 fusion se
Senior Member
That work's too Dave, I had just got my gas tank filled for my Mig and just wanted to weld up a little som.. something!
...
i love when welding goes right, kinda like paint. but when it goes wrong i wana throw it all in the garbageOriginally Posted by musclemerc
2010 fusion se
Senior Member
Very True! I was just priming up for the doubled up stock control arms... Remember those?
...
cant say that i do
2010 fusion se
Senior Member
Take two pair of the factory upper and lower control arms and remove the bushins and weld them together. Re-install the bushins and you got a strong set of upper and lower CA's. I have a DIY powdercoating kit so I will got the extra step and PC them. Control arms on the cheap!
...
i have a PC setup also but havent finished my custom oven yet.
2010 fusion se
Senior Member
Gotta love tools!
Senior Member
Only 1 left... Anyone else?
'God Speed Blues Brother'
If it doesn't say "Binford", someone else made it. - Tim Allen, Tooltime
2003 300B DBP
Build date: 6/19/03
Number 7,792 of 7,838 - 326 of 328
Proud member of the MM "BLUES" Bros.
Purchased: 11/10/05
Eaton swap by ImpalaSlayer 11-09-10
Semper et in Aeternum, Mercurius.
In Memory:
2004 DTR
Build Date 01/27/04
Purchased 04/04/04
Wrecked 10/19/05, R.I.P.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
