Replacing Blend door actuator

[Flynlow]

Ok, I am struggling a bit here, mainly cuz I am trying to be lazy in almost 100 degree temps...

I am replacing my Blend Door Actuator switch. I have gotten the 3 defroster grill bolt loosened and the lower right hand dash nut and lower left hand dash bolt and nut. My dash is still not "wrigglin" enough to move dash to gain access.

Is it possible to get the dash moved back and up enough to gain access to the actuator this way ?

Any comments / help would be GREATLY appreciated.

FYI -- This is on an 04 CV with ATC if that matters much...

[Spectragod]

You need to remove the bolts in the middle at the transmission hump. Remove the glove box door and the right side air bag. Then, you can pull the dash back a few inches and you will be able to access the bolts. Good luck.