Looks great!
I love the bell mouth inlets....reminds me of an old school injector stack!
Just an observation:
The injectors are not really bolted to the manifold, they're just held in place by the fuel rails, and are not a structural/stressed piece....
Is it necessary to do all that additional welding on the outside before/after you 'shave down' the injector bungs?
(Before I had my intake extrude honed, I took a Dremel to all that crappy casting flash and the manifold was smooth on the inside and the outside.)
Last edited by Joe Walsh; 01-30-2012 at 08:31 PM.
2020 Ford Ranger STX DFI Turbo 2.3L 10 speed Auto
2017 Ford Fusion Sport DFI Twin Turbo 2.7L V6 6 speed Auto (14.000 ET bone stock in 82 degree heat)
1985 Mustang GT 5.0 Hatchback 4bbl 5 speed manual (525 HP 363 Dart block/AFR heads with Magnum 6 speed in the works)
1984 Mustang GT 2.3 Turbo Convertible FI. 5 speed manual
1966 427 Cobra (ERA) 468 all Aluminum FE 2x4bbl 5 speed manual
SOLD : 2003 Mercury Marauder FI. 4 speed Auto
w/Crower Cams & Springs, +1mm SS valves, mild port job on the cylinder heads.
Extrude honed intake w/PHP spacer.
Kooks Headers w/2.5" High Flow Cats & X-Pipe, Magnaflow mufflers, OEM tailpipes w/Megs Tips
B&M Trans cooler w/fan, Level 10 Shift Kit, Art Carr Hughes Deep Sump Trans Pan,
SVO Rearend Girdle, Redline Gear lube; OEM 3.55s
'Real Gauges' + matching Trans Temp, Oil Temp, Water Temp, Fuel Pressure, Vacuum/Boost Gauge
Built: 10/15/02 Bought: 12/16/02 Sold: 10/15/18