So i checked my TPS and it was reading 1.109 so i adjusted it to read .99volts. stroked the TB and it read 4.555 at WOT. had a buddy watch my fuel pressure gage while i went from idle to WOT and it was reading 40psi. Not sure what it should be reading with 39# injectors. kind of seemed like it was not getting enough fuel because it was cutting out and the traction control light was flashing again, except this time it was at around 3600rpms and would climb any further. if i gradually push down on the gas it climbed with no problems. if i gradually pushed down on the gas to about 3600rpms then go to WOT it immediately cuts out again. Madness! could really use some info or suggestions on this issue.