MercuryMarauder.net Forums    

Go Back   MercuryMarauder.net Forums > The Garage > Shop Talk

Shop Talk Visit Shop Talk for all your general technical discussions regarding the Marauder!

Reply
 
Thread Tools Display Modes
  #31  
Old 09-13-2018, 08:59 PM
MyBlackBeasts's Avatar
MyBlackBeasts MyBlackBeasts is offline
T242 - Ricer ricer
 

Join Date: Aug 2011
Location: Wisconsin
Posts: 3,289
Trader: (7)
Quote:
Originally Posted by Chayton View Post
Someone mentioned you can change the fuel pump without dropping the tank. How?? My blue marauder stutters BAD when 3/4 throttle in any sort of TURN left or right. As you turn it stutters and then goes. Fuel pump?

Run or pump fuel level down below fuel sender access hole, remove sender/pump, replace and reassemble. = Done
__________________

WLB
BB#1) 1996 ImpalaSS - 16,500 miles - 100% stock
______________________________ ___________

BB#2) 2003 Marauder (300a) - 34k miles - Daily Driver
#2912 of 7093
Conceived 8/6/2002
Delivered 9/19/2002
Adopted 8/10/2011
Trilogy 242 - Self Installed 9/9/12 (0-60 5.5 sec)
Pioneer 6x8 Front
Legacy 600w 6x9 Rears
JL 6.5 SubWoofer
K&N CAI
Window tint 50% rear/35% front
FBM CHMSL with Strobe mod 7/1/12
DR Deep Aluminum Trans Pan
Sparta FOMOCO Racing 8.8 Girdle
Mo's Dyno Tune
Gorilla Nuts - The System
Ford Racing 4.10s, 31 spline Cobra carrier & axles 7/1/12
Powder Coat Axle Housing 7/1/12
CME HP Rear Control Arms & Watts Link 7/1/12
______________________________ ________________

Rex "SC Cheesehead" Weinbender 11-14-13
Ed "Baaad GN" Linthicum 8-6-2014
Reply With Quote
  #32  
Old 09-14-2018, 04:18 AM
justbob's Avatar
justbob justbob is offline
Sick-Speed play toy
 

Join Date: Mar 2008
Location: Couple of car lengths ahead of you
Age: 45
Posts: 18,700
Trader: (11)
Quote:
Originally Posted by MyBlackBeasts View Post
Run or pump fuel level down below fuel sender access hole, remove sender/pump, replace and reassemble. = Done


Also to add. Remove right side tail pipe from its hanger and pull down. Also remove tape from wiring directly above the access hole to allow enough slack to remove the pump.

The wiring turns down towards the pump but other wires keep traveling towards the passenger side, those wires stay, just separate them till you have enough.


Sent from my iPhone using Tapatalk
__________________


Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.
Reply With Quote
  #33  
Old 09-14-2018, 04:33 AM
Chi Stallion's Avatar
Chi Stallion Chi Stallion is offline
Senior Member
 

Join Date: Jul 2010
Location: Crook County
Age: 31
Posts: 250
Trader: (0)
Quote:
Originally Posted by Ambitious1 View Post
I know this is an old thread, however I am starting to notice some rough idle when I first start in the morning. As soon as the engine warms up, she smoothes out and she's fine for the rest of the day. I cleaned the CAI, replaced the MAF sensor and put two new 02 sensors. I am now thinking it may be the IAC. Before I buy more parts, I am curious what does everyone use to clean the IAC? I am thinking the CRC Throttle Body & Air-Intake Cleaner should work.

https://shop.advanceautoparts.com/p/...5078/7040065-P

Does anyone have any other suggestions or ideas? Thank you in advance.
while the engine is running disconnect the IAC connector. The engine should stumble and die immediatley. If it does this, that means your IAC is good.
__________________
300A 8-20-02
Webasto Aftermarket Moonroof
Rear Spoiler
S55 Tail Light Treatment
5% Limo Tints
Fresh Black Paint Job 11/11/2011

Stainless Works Headers & Full Exhaust System, Magnaflow Mufflers, Martyo Tune, JLT CAI & Catch Can, J-Mod, Rebuild 4R70W, Dynotech 4' 6061, Forced Lube Mod, EMP Stewart WP, Steeda UDP, 31 Ford Spline Axles, 31 Cobra Carrier w/CF Clutchs, Ford Racing 4.10 & M-4210-C3 Master Kit, TA Girdle & Stud Kit, Carfixer Alignment, Cooper Zeon RS3A Tires, Metco Control Arms & Watts Link, Addco F/R Sway Bars, E/S Bar Bushings, Monroe Severe Shocks, SS Brake Lines, Napa Adap1 Brakes & Ultra Prem Rotors, AM Digital Oil & Volt Gauge, DDM HIDS 5K h/l & Fog Lights 5K, Full LED Upgrade, Alpine IVA-W505/P1, PKG-M780 Headrest Monitors, PXA-H100 Imprint, MRP-F300 4 channel, Rockford Fosgate 1501BD, SPR-60C & SPR-60 Speakers, HCE-C1100 & KTX-C10LP Camera System, Viper 5901 & VSM350 GPS SmartStart System, Yellow Optima, Stinger Digital Batt Term, BIG III & 200 Amps Alt
Reply With Quote
  #34  
Old 09-14-2018, 01:53 PM
crouse's Avatar
crouse crouse is offline
I know nothing
 

Join Date: Feb 2006
Location: Rosemount, MN
Age: 54
Posts: 1,757
Trader: (1)
What do you clean the IAC with? Can you use MAF cleaner?
Reply With Quote
  #35  
Old 09-14-2018, 02:42 PM
RF Overlord's Avatar
RF Overlord RF Overlord is offline
73 is the best number.
 

Join Date: Sep 2002
Location: Cape Cod, MA
Posts: 13,607
Trader: (2)
MAF cleaner or coated throttle body cleaner. Don't use carb cleaner or Brakleen...
__________________
The Blackbird
Trilogy #61
Driveway Queen

The Spruce Goose
2004 Grand Marquis LS Limited Edition
Daily Driver
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Rough idle walela1 Shop Talk 14 07-31-2009 06:32 AM
Rough idle wont go away james1986fox Shop Talk 5 03-17-2009 06:10 PM
Rough at idle mtenderenda Shop Talk 14 07-16-2008 05:05 PM
Rough / Low Idle arejayesss Shop Talk 14 09-26-2007 05:54 AM
Missing and rough idle Festus Shop Talk 43 10-08-2003 08:17 PM


All times are GMT -7. The time now is 06:58 AM.


Powered by: vBulletin
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright ©2002 - 2017 - MercuryMarauder.net