What did you do to your car today?

[-Matt-]

Looked at it as i walked by her and got into the CVPI to drive to work

[Go2GuyFL]

Replaced the bulbs over the license plates in both cars as they were each burnt out. Very strange.

[Leadfoot281]

I put tags on mine. The old ones expired in July '09. Due to road construction (and winter) I haven't driven or started mine since last July.

Hopefully they get my road paved this year.

[LIGHTNIN1]

Put the new sticker on the tag and cranked her for a few minutes. Had it a year now.

[Mr. Man]

Looked at it and decided it needs to be vacuumed out before Kentucky trip.

[1 Bad Merc]

I kicked it after I saw the coolant laying on the ground! She's an evil one....

[Speed]

Made arrangement to have driveshaft install, now time to go order that loop. Maybe that rear addco swaybar as well.


BTW where is the best place(s) to buy 31 spline axles and 31 spline detriot tru-loc? Plan is to replace rear in couple mths being that I have one of those early 03s. Thanks ahead of time.

[stryker]

take it to western auto to did some repairs
1- replace rear axle bearings,retainers,change Diff. fluid.
2-Replace 4 brake discs and brake pads and a flush of the brake system.
3-replace of the air filter.
4-change oil/oilfilter
5-put 4 new shoes(tires) Nexen CP672 P235/60R16
6- buy an Escort Passport 8500 radar detector
7-buy an Kenwood ipod interface KCA-IP500

Parts in schedule to install
1-Marauder airbox with K&N air filter charger (Thanks to Cougar 9150)
2-4 Marauder shocks

[massacre]

Worked a little bit on the pass. side half of my coolant crossover tube, from a markviii.
Had to cut off the markviii bracket and weld on a Mach 1 bracket to match the other half which is stock mach 1. Keeps both temp sender bungs that way.
It's done I was just cleaning it up some before primer.

[Mr. Man]

Took it for a ride and made Ms.D drive it to get her impressions of the new suspension work. She agrees it no longer pushes like a dump truck in the corners. Still not in Porsche territory yet but gaining on it.

[stryker]

In present time washing The M-panther, vaccum the inside while I listen to music with my iphone !ups! i knew I forgot something in the first post of this thread, i buy an itrip for the iphone so the music stored in the iphone i an listening through the radio of my Panther, later I will post pics.

[Blackened300a]

Full compound, wax, engine and interior detail. Tomorrow is the first car show of the season and I plan to be prepared to start 2010 with a win.

[BUCKWHEAT]

Postman delivered my new FRPP 3:73's to replace the 4:30's. Picked up my wheels after the shop installed the new Nitto tires, 295s on the back & 235s on the front. Put the old OEM 10k mile fronts on my Kazerra rims that have the Nitto 305 DRs on the wider Kazerra rears.
This weekend, I hope to replace four sets of brake pads, new plugs, clean MAF & the K&N.

Ended up replacing all the brake pads before installing the new Nittos. Looked like some front brake pistons were binding up since inside pads didn't have the same wear as the outside pads. Shot some solvent on them. They seeemed to bite hard after I warmed them up a bit. If they don't all loosen up, then back to Todd for re-do. Nittos seem quieter and firmer than the OEM BFG's.

[guspech750]

I moved it down the driveway so I could cut lots of wood with my compound miter saw. The I moved it back up the drive way. Sounds exciting right?

[Mr. Man]

I moved it down the driveway so I could cut lots of wood with my compound miter saw. The I moved it back up the drive way. Sounds exciting right?

It is if it's a sliding compound miter saw with laser guides