Any one have a good source for the door mouldings. Mine are peeling and need repainted so planned to purchase replacements and have them painted
Joe
Any one have a good source for the door mouldings. Mine are peeling and need repainted so planned to purchase replacements and have them painted
Joe
2004 SB
4.10's and a tune
More to come
Sand and repaint the ones you have......not a bad job!!
No Marauder
obsolete item from ford, no known aftermarket matching ones. refurbish yours unless one of these cars being parted out has them avsil. to repaint
2004 SB Ported Trilogy 48
Has supporting mods and stuff
Thanks to Marty O for his help in updating this car.
R.I.P.
Rex "SC Cheesehead"
Still available (as per parts.ford.com) ...RubberCtyRauder - obsolete item from ford ...
- Fender
• 5W7Z-16036-APTM - RH
• 5W7Z-16037-APTM - LH
.- Door (front)
• 5W7Z-5420878-APTM - RH
• 5W7Z-5420879-APTM - LH
.- Door (rear)
• 5W7Z-5425556-APTM - RH
• 5W7Z-5425557-APTM - LH *Currently on back-order
NOTE: All are Paint To Match.
Also, can substantiate that at least the LH front fender trim was available as of Sep'2017 - had need to buy one.
.
alot of those part's websites do not update regularly..and you order and get an email that out of stock, discontinued etc.
2004 SB Ported Trilogy 48
Has supporting mods and stuff
Thanks to Marty O for his help in updating this car.
R.I.P.
Rex "SC Cheesehead"
Am fully aware, and have 1st knowledge, of that. HOWEVER ...RubberCtyRauder - alot of those part's websites do not update regularly..and you order and get an email that out of stock, discontinued etc.
parts.ford.com is the official FoMoCo parts web site -AND-
just checked tascafordparts.com and got the same results (parts listed, and shown).
That and as mentioned ... "can substantiate that at least the LH front fender trim was available as of Sep'2017 - had need to buy one.".
So if you're into OEM, NOS wouldn't hurt to check-with your local, friendly FoMoCo dealership parts counter for availability either thru existing stock or the FoMoCo parts network.
Shoot Fire ... -ALL- (including 5W7Z-5425557-APTM) are even currently on ebaY® ... so much for being -obsolete-
.
I think I have a full set minus the drivers fender one, was damaged
The same moldings are found on OTHER than marauders too, might find some at the yard
The twins2.3 whipple/aluminatorVortech V-2 lots of goodies
Current marauders
04 DTR totaled JUST NOW starting to part out 7-21-2021 https://youtu.be/REUxjP1BVpg
04 Silver Birch Dark Charcoal Hardtop Whipple Supercharger
04 Silver Birch Dark Charcoal Hardtop V2 Supercharger
04 Silver Birch Dark Charcoal Converted
03 DBP Light Flint #122
03 DBP Dark Charcoal #232
03 Silver Birch 300b Light Flint Going to fix er up
03 Black 300a
04 Silver Birch Dark Charcoal moonroof in the works
04 Heaton Swapped DTR
Joe's Wrecked DTR rebuild thread
Get a piece of aluminum flashing and slide it down behind the molding to protect the door while you wet sand the bad places......then mask, prime and paint....EASY PEASY!!
Have you even tried to remove those moldings yet......it's a NIGHTMARE!!
No Marauder
Waiting to hear back from the body shop to see if they would be able to repaint them on the car. Last place I talked to when I first got the car would touch it with them still attached
Sent from my SM-G955U using Tapatalk
2004 SB
4.10's and a tune
More to come
i was not aware that the door moldings were still available, i was going by older info that mentioned can't find them, get them...can get door moldings, but a headlight? or cross over tube?. i need nether, just as comment
2004 SB Ported Trilogy 48
Has supporting mods and stuff
Thanks to Marty O for his help in updating this car.
R.I.P.
Rex "SC Cheesehead"
1998+ Crown Victoria - P72 (commerical - standard wheelbase), P73 (civilian - base) and P74 (civilian - LX) models.Turbov6Bryan ... The same moldings are found on OTHER than marauders too, might find some at the yard
.
I may have a set.
Let me do some looking.
Bought from Go-Parts in August
998 - 2008 Ford Crown Victoria Rear Door Molding Right (Passenger)
Item #: DM0001-0899068-0633249
$57.95 USD 1 $
1/4 Mile Time 11.542 @ 121.19 MPH
195,000 Miles & 275+ Runs Down the 1,320’
541.57 RWHP & 476.64 RWTQ on DynoJet
Tuned by Aric at Injected Engineering
Vortech Super Charger V-2 “T” Trim, 19 PSI
8 Rib Belt, Innovators West 10% Overdrive Dampner
Air to Air Intercooler, Mini-race Bypass
Ford Cobra Remanufactured Long Block
Snow Performance Water-Methanol Injection
Kooks Headers & X Pipe
GT MAF, 60lb injectors, Dash 8, Aero Rails, Twin Ford GT Pumps,
Kinsler Fuel Filter, Kenne Bell Boost-A-Pump
Monroe Sensatrac, Metco Control Arms, Addco Rear Sway Bar
31 Ford Spline Axles & Detroit Truetrac, 4:10 Ford Racing Gears
Dynotech MMC Driveshaft
A-1 Performance Trans, Forced Tailshaft Lube, Carbon Clutches
3,500 RPM Stall Precision Industries Torque Converter
B&M Deep Finned Trans Pan
AeroForce Scan Gauges , Auto Meter Oil, Fuel & Boost Gauges
Kenny Brown Dead Pedal, 35% Tint, Silver Star Head Lights
AutoPage Alarm RS-727LCD, Boston Acoustic NX87
There are currently 1 users browsing this thread. (0 members and 1 guests)