So it appears that the fan on the 224k beast is working intermittently. I haven't had a chance to look at anything as yet. First thing I will be doing is checking the linkages to make sure they are corrosion free and secure. After that... thoughts?
So it appears that the fan on the 224k beast is working intermittently. I haven't had a chance to look at anything as yet. First thing I will be doing is checking the linkages to make sure they are corrosion free and secure. After that... thoughts?
Black 2004 Marauder with bun warmers, escape hatch and 20% tint.
#3200 of 3214 built #1230 of 1237 in black
1988 Dodge Diplomat SE "Grandma"
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
Cooling. For example: on the way to work this AM, traffic came to a standstill and I noticed the temp was at the high end of the normal range. Didn't overheat, but close to it. This is in 32º weather with no wind. I cranked the heater and then opened the roof so I wouldn't sweat and it helped a little. Once traffic got to moving the airflow got it back down to 1/2 way which is about where it usually sits.
Black 2004 Marauder with bun warmers, escape hatch and 20% tint.
#3200 of 3214 built #1230 of 1237 in black
1988 Dodge Diplomat SE "Grandma"
Is the coolant full? Recently opened? If the coolant is full, not recently opened, and no leaks, I would datalog the coolant temp switch to rule that out next.
Then move onto the relay, fan, and the controller.
Sent from my iPhone using Tapatalk Pro
SOLD 12/31/2021
Cobra short block / ProCharger F1-A / Cog drive upgrade / Manley valves / Brian Tooley Racing valve springs / 80# inj. / -8 fuel line / -6 return / Aeromotive 340 pumps and regulator / 2012 GT500 TR6060 six speed / twin disc clutch / Driveshaft Shop GT500 upgraded CV joint shaft / BA5000 blow thru MAF/ 4.10's / Ford Racing 31 spline set up and Girdle / Metco D.S. safety loop / Stainless Works headers, cats, and everything else out back / ClassGlass hood / Bob's hood strut mod / Hurst line lock / Metco control arms / Addco front and rear sway bars / Monroe severe duty shocks all around / Race concepts rotors / Badgeless grille / 35% tint / FBM's interior LED kit and ambient lighting kit / Pioneer FB700 deck / kenwood speaker 4 Ch. / Rockford Fosgate 10" sub and amp / Kicker 6 X 8's all around / back up cam / bluetooth / Pioneer Xm / 704 RWHP 603 RWTQ tuned by Mo's Speedshop.
Any weird noises? Had one where the ring around the fan cracked. Run the car, put the A/C on, the fan should come on high. Check coolant level. The overflow tank cap may need to be replaced and system burped.
“When you can’t make them see the light, make them feel the heat.”
Ronald Regan
"The only way to deal with the Islamic State - these blood thirsty, blood-drunken, terrorists -
is to kill them, keep on killing them, until you kill the last one, then you kill his pet goat."
Lt. Colonel Ralph Peters
“Be polite, be professional, but have a plan to kill everybody you meet.”
"I come in peace. I didn't bring artillery. But I'm pleading with you, with tears in my eyes, if you **** with me, I'll kill you all"
General James Mattis
Thanks, gents. I'll be in my driveway Sat. morning following your advice as best I can.
Black 2004 Marauder with bun warmers, escape hatch and 20% tint.
#3200 of 3214 built #1230 of 1237 in black
1988 Dodge Diplomat SE "Grandma"
There are currently 1 users browsing this thread. (0 members and 1 guests)