Originally Posted by
BillyGman
I'm thinking that it would be a good idea to put some type of thread sealer on the threads of those center bolts, as well as on the jam nuts in order to prevent leakage. After all, there's a gasket keeping leaks out that's around the outside cover bolts, but there isn't any gasket that the center load bolts go into. right? What do you guys think?
Billy, mine also leaked around the drain plug so a little thread tape their as well
'03 Mercury Marauder Born 8/02 Adopted 9/02
Vortech Supercharger w/ WA intercooler
Race prepped block
Cobra block
CP Pistons
Manley Forged H-Beam rods
Billet oil pump gears
Stud Girdle (Its pretty)
MMDS Drive Shaft, Metco Contrl Arms, Metco Watts Link, X-CAL2
Meziere Ele. Water pump
Addco Rear sway bar, Addco front sway bar
PI 3000 stall torque converter
4:10 Ford Racing gears, Ford Racing Rear end Girdle
Rear engine cooling kit
A-piller gauges- boost and fuel pressure
KVR custome Brake KIt - RED
Cobra exhaust manifold with X-pipe
Level II tranmission kit
180 STAT.
Art Carr deep Tranmission kit,Tranmission cooler
KVR stainless steel brake lines
High preformance Twin cobra fuel pump, Reinhart HP fuel Filter
Bob White decals on side mirror, side windows & bumper inserts,
Splash Gaurds, KB Dead Pedal
Eaton Diff. Mos. 31 spline axles